User's Manual
Table Of Contents
- Index Page
- ● Contents of the product CANICOM 200 First
- ● Checking/replacing battery of remote control
- To check the condition of the battery, observe the indicator light located on the front of the remote control. If the light indicator flashes green 3 times when you press a button, the battery is weak.
- Performance (radio range) of the remote control deteriorates as battery becomes weak. You should soon replace the battery.
- ● Checking/replacing battery of receiver collar
- ● Maintenance
- ● Troubleshooting
- ● Technical specifications
- ● Receiver collar battery life
- ● Guarantee
- ● Guarantee conditions
- ● Spare parts
- ● Collection and recycling of your device at the end of its life
● Contents of the product CANICOM 200 First
Inside the packaging you will find:
- a CANICOM receiver collar equipped with short contact points
- a 3 Volt CR 2 lithium battery for the collar
- a CANICOM 200 First remote control equipped with a 3 Volts CR 2430 lithium battery
- a neon test lamp
- a pair of long contact points
- a carry strap
- this user’s guide
●
Description of the product
Indicator of radio transmission
+ battery level indicator
Red mark:
area where the
On/Off switch
magnet is located
Continuous stimulation
level 5
RECEIVER COLLAR
Diagram 2
REMOTE CONTROL
Diagram 1
Beeper
button
Continuous stimulation
level 1
2 contact points
(short or long)
On/Off indicator
+
indicator of
radio reception
+
battery level
indicator
Continuous stimulation
level 3
Continuous
stimulation
level 2
Continuous
stimulation
level 4
●
First use from new
Fitting the battery in the receiver collar
▪ Unscrew the 4 screws of the top of CANICOM using a screwdriver.
▪ Insert the battery (3 Volt CR 2 Lithium)
paying attention to follow the polarity indicated on the battery
housing (ref. Diagram 3). The tab is under the battery.
▪ A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after inserting the battery, immediately remove it from its housing. Check the
polarity before trying again.
▪ Before putting the lid back in place, check that the rubber seal is in its groove. Make sure the tab is in correct
position (inside the battery housing) to maintain water tightness.
▪ Retighten moderately the 4 screws.
Polarity “+” of the battery
Seal
Activate/deactivate the remote control
Polarity “-” of the battery
Diagram 3
Remote control is supplied with battery fitted.
▪ Activate: as soon as the battery is in place, the remote control is ready for use.
▪ Deactivate: if the remote control is not to be used for a long period or if you wish to turn it off, you should
remove the battery from its housing.
Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch On/Off the CANICOM receiver collar.
User’s guide CANICOM 200 FIRST – indice A 3/8