User's Manual

▪ Activate: approach the red area where the magnet is located inside the remote control until coming in contact
on red mark located on the receiver collar for 1 second (ref. Diagram 4). The indicator light on the collar will
flash in green indicating the CANICOM receiver is ready.
▪ Deactivate: approach the red area where the magnet is located inside the remote control until coming in
contact on red mark located on the receiver collar for 1 second (ref. Diagram 4). The indicator light on the
collar will flash from green to red and then off: the CANICOM receiver is off.
Approach until coming in
contact those 2 areas
during 1 second
Diagram 4
To increase the battery life of the remote control and receiver collar, you should deactivate the units if
you are not using them for a long period.

Coding of the remote control and receiver collar
Each remote control has its individual radio operator code. The coding of the remote control with the receiver collar
enables to couple your remote control with the receiver provided.
IMPORTANT: before beginning the coding (first use of receiver or re-coding), make sure no other person
is using his CANICOM 200 First or other products from the NUM’AXES range close by: your receiver collar
could accidentally record the code of his remote control. If that occurs, re-code the remote control with
the receiver collar.
CODING PROCEDURE FOR THE 1
ST
USE
To code, the remote control must be ready for use (battery in place).
1. Activate the receiver collar: approach the red mark located on the remote control until coming in contact on
red mark located on the receiver collar for 1 second (ref. Diagram 4).
2. Move the remote control away from the receiver collar.
3. Press the beeper button
of the remote control. A sound beep is emitted, the receiver collar is then
synchronized with your remote control.
RE-CODING PROCEDURE (for all coding procedures except the 1
st
one)
To re-code, the remote control must be ready for use (battery in place).
1. Receiver collar
in position “deactivate” (indicator light off): approach the red mark located on the remote
control until coming in contact on red mark located on the receiver collar
for 6 seconds. The indicator on the
receiver collar lights in fixed green, then flashes in red.
2. Move the remote control away from the receiver collar.
3. Press the beeper button
of the remote control. A sound beep is emitted, the receiver collar is then
synchronized with your remote control.
 Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new remote control
from the CANICOM range (Ref. Re-coding procedure).
● How to use the remote control
The CANICOM 200 First remote control is designed to operate with one receiver collar. For optimal range
performance, hold the remote control in front of you with your arm extended, at least 10 inches away from your
body. Do not cover the top of the remote control unit or antenna with any part of your hand while holding.
 button: beeper
User’s guide CANICOM 200 FIRST – indice A 4/8