DM-950 DJ Mixer Operating Instructions INSIDE THE BOX: (1) DM-950 DJ Mixer (1) DM-950 Power Adapter
Thank you for buying this Numark product package. Please read these operating instructions so you will know how to operate all of this equipment properly. After you have finished reading these instructions, keep them for future reference. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment.
CAUTION! TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. IMPORTANT The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
MIXER CONTROLS General Mixer Controls for DM-950 1. AC In and Power Switch This mixer is compatible only with the included power cable. Connect the AC plug into the jack on the rear of the mixer (A.) The mixer should be switched on after all devices are already connected to prevent damage to your equipment. A Red Power LED indicates that the unit has been switched on. 2. Master Volume This rotary control adjusts the main output levels for any equipment connected to the Master Output on the rear panel (B.
2 1 3 4 5 6 7 8 9 11 10 G A H B C MIXER CONTROLS D E F PAGE 4
MIXER CONTROLS continued Input and Power Section NOTE: It is recommended that the mixer be turned off before connecting or disconnecting anything to/from the mixer. A. Power Switch and AC Jack Use only the included AC Power Adapter when operating this mixer. See Control 1 for additional notes on powering the mixer. B. RCA Master Output This RCA output is for connecting an external monitoring device such as a PA system, powered monitors or a home stereo.
SETUP & INSTALLATION This mixer was designed to be placed between turntables and table top CD players. It is important that there is at least ΒΌ" (7mm) between the mixer and the turntables or CD players to prevent damage to the equipment and to reduce unwanted system noise.
SPECIFICATIONS Inputs: Line: Mic: 18K ohm input impedance 200mV rms sensitivity for 4V output 3K ohm input impedance unbalanced 2mV rms sensitivity for 4V output 20mV rms max input Phono: 47K ohm input impedance 3mV rms sensitivity @ 1KHz for 4V output Outputs: Master: Headphone: Distortion: 8V rms max 125mW into 32 ohm less than 0.
LIMITED PRODUCT WARRANTY 1.
RETURN INFORMATION (US ONLY) a) A Return Authorization number must be obtained from Numark through the address or phone numbers below. b) A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. c) The faulty equipment must be packed in its original packaging. d) One additional outer layer of packaging must be included to ensure product safety.
Problem Cause? Solution Mixer does not turn on. Disconnected Power Cord? Connect Power Cord. The sound level is very low. The Turntable is not connected to a device with a PHONO preamp. Connect the turntable to the input labeled PHONO, not the LINE. The sound is on one side only. The RCA audio cord is disconnected. Properly secure the RCA cable to the mixer. The RCA audio cord is damaged.
INSIDE THE BOX: (1) DM-950 DJ Mixer DM950 Manual/ English (1) DM-950 Power Adapter Copyright Numark Industries, LLC 2002
