Amplifiers Owner's Manual SA3000, SA5500, SA9500

3. ensure that there is only one input signal connected

to channel 1 of the amplifier - channel 2 input must be

vacant

4. switch the amplifier to bridged mono (back panel

switch)

5. turn the gain down and turn on the amp

6. verify operation at low gain, and then increase power

to desired level, ensuring that the gain controls on

each channel are set equally.

IMPORTANT: NEVER SWITCH BETWEEN

STEREO AND BRIDGED MONO OPERATION

WHEN THE AMPLIFIER POWER IS ON.

11. Limiter On / Off Switch

In cases where a dedicated compressor / limit unit

precedes the SA5500, some users may seek to disable

the on board limiting. Sliding the switch to the off position

removes the limiting from both channels of the amplifier.