Operation Manual
Information for DRY USE Vacuum Cleaners
Ensure you read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines, as with all electrical equipment, care and attention
must be exercised at all times during use, you must also make certain that routine and preventative maintenance is
carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render this
equipment unsafe and the manufacturer can accept no responsibility in this respect.
This machine is for DRY USE only
You must disconnected the machine from the mains by removing the plug from the supply socket BEFORE cleaning or
maintenance and when replacing parts or converting the machine to another function.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not suitable for the collection of biological hazards, hazardous or explosive dusts.
Contact your local distributor if you require a machine capable of performing these tasks.
The machine must not to be used by persons with reduced physical, sensory or mental capabilities, or lack of experience
or knowledge, unless they have been given supervision or instruction.
You must not allow the supply cord to come into contact with rotating brushes (if tted).
Only use the socket outlet on the machine for purposes specied in the instructions (where tted).
This machine is not a toy; children shall not play with this machine.
This machine must not be stored outside, or used in wet environments, or to collect wet materials. The vacuum cleaner
should be stored in a dry place and is for indoor use only.
You must ensure that the ltration system tted to the machine is suitable for the material being collected.
This product complies with the requirements of IEC 60335-2.69.
This machine is suitable for commercial use, for example in hotels, schools, hospitals,
factories, shops and ofces for other than normal housekeeping purposes.
If the vacuum cleaner stops working, remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet, and inspect the oor tool, wands
and hose for debris. If the oor tool, wands and hose are clear, replace the dust bag and clean the lter.
The vacuum cleaner should be inspected after use for damage.
● Keep your machine clean.
● Keep lters clean.
● Use lter bags, they will enhance performance and help keep machine clean.
● Use a Numatic Original lter bag under ne dust conditions.
● Keep hoses and tubes clear.
● Replace any worn or damaged parts immediately.
● Regularly examine the power cord. If damage is found such as cracking or ageing the power cord must be replaced by
a qualied person using the correct Numatic original part.
● Change dust bag frequently.
● Keep diffuser lter (where tted) clean.
● Only use the brushes provided with the machine. The use of other brushes may impair safety.
● Unreel the cable with one pull or pull on the cable to unplug the machine from the power supply.
● Use to suck up hot ashes, lighted cigarette ends or ammable gases.
● Use steam cleaners, pressure washers or immerse in water to clean the machine.
● Attempt machine maintenance or cleaning unless the power supply plug has been removed from the supply outlet.
● Use in a wet environment or to collect wet materials.
● Store your machine in wet conditions.