Operation Manual

233970 (Page 34) 10/11 (A13)

Regular Maintenance

ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED

PRIOR TO ANY MAINTENANCE OPERATION

! !

After use, empty waste-water tank using

emptying hose and ush-out with clean

water.

Remove the two hoses to disconnect the separator from the

machine (Fig 28).

Lift off the separator. The separator has a sealing-rubber

which should be examined at every clean-down (Fig 29).

Rinse using clean water.

NOTE:

Avoid over tightening the clean water draining cap.

The TTB 1840 has been designed with ease of use in mind, this included easy stripping-down and cleaning.

Remove the two lters clipped into the separator and ush with clean water (Fig 30)(Fig 30a).

Replace by tting the rear of the lter rst then clipping the front to lock in place (Fig 31) (Fig 32).

Disconnect and remove the

battery before proceeding with

tank removal (Fig 33).

Once emptied the top

waste-water tank can simply be

lifted off. (Fig 33a).

The clean-water tank can be drained via the yellow cap tted

to the left hand side of the machine. The cap has a rubber

seal and might require a spanner to remove. (Fig 34).

Fig 28

Fig 29

Fig 30 Fig 31

Fig 32

Fig 33

Fig 34

Fig 30a

Fig 33a