Operation Manual

233970 (Page 38) 10/11 (A13)

Changing the Floor-Tool Blades

! !

ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED PRIOR TO ANY

MAINTENANCE

To change the oor-tool, rstly swing the oor-tool clear of the

machine (Fig 41).

Undo the two oor-tool retaining knobs (Fig 42).

Unscrew the four knobs securing the blade holder (Fig 43).

Remove the blade holder (Fig 44).

Replace the Squeegee blades using (606261) replacement blade set (Fig 45), tting the blades on to the moulded

location lugs.

Ret the blade holder, retain using the two outer knobs

(Fig 46)

Retting the Floor Tool Blades

Ensure the slotted blade goes to the front of the

oor-tool (Fig 47).

Ret the oor-tool using the two central knobs to

the oor-tool.

Refer to Page 9 for tting instructions.

1. Floor-tool main body

2. Blade carrier

3. Rear blade

4. Front blade (slotted)

5. Retaining Knobs x 4

Fig 41

Fig 42

Fig 43 Fig 44 Fig 45

Fig 46

Fig 47

Note:

The blades are designed to be reversible, thus

extending their useful working life.

Use Genuine NUMATIC spare parts.

use

Replacement Blade Set (606261)