Operation Manual
12
When handling and mixing chemicals.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
After use, ensure the chemical dosing tank is emptied, cleaned and relled with clean water.
The dosing pipes also need to be cleaned and ushed through with clean water for at least 60 seconds after use.
! !
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
! !
Note: always ensure that the waste-water tank is empty before lifting.
The TTV-5565 scrubber dryer has an optional automatic chemical-dosing system.
Simply ll the 1.32 gall chemical dosing bottle and the machine will deliver the correct mix ratio as set by the
operator,depending on the oor and cleaning conditions.
To ll the chemical-dosing bottle, rst make sure the top waste tank is fully drained then, lift up the waste-water tank
(Fig.18), remove the dosing bottle, unscrew the bottle cap (Fig.19) and ll with appropriate cleaning chemical, or t
your own chemical container, reusing the original Numatic container cap 1.5 inch / 1.65 inch (Fig 19a).
Ret dosing bottle (Fig.19b) and replace
bottle cap, and carefully lower waste-water tank.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place-out appropriate warning signs and sweep or dust-mop the oor.
Fig.18
Fig.19
Fig.19b
Fig.19a
Chemical dosing system