Use and Care Manual
13
12
HTTP://WWW.NUMAXTOOLS.COM 1-888-669-5672 HTTP://WWW.NUMAXTOOLS.COM 1-888-669-5672
MODEL: S18GLCNDH MODEL: S18GLCNDH
Do not at any time let brake fluids,
gasoline, petroleum-based products,
penetration oils, ect. come in contact
with plastic parts. Chemicals can
damage, weaken, or destroy plastic
which may result in serious personal
injury.
WARNING:
!
COLD WEATHER OPERATION
For cold weather operation, near and below
freezing, the moisture in the air line may freeze
and prevent tool operation. We recommend the
use of air tool lubricant or permanent antifreeze
(ethylene glycol) as a cold weather lubricant.
Do not store tools in a cold weather
environment to prevent frost or ice
formation on the tool’s operating
valves and mechanisms that could
cause tool failure.
CAUTION:
RECOMMENDED HOOKUP
The air compressor must be able to
maintain a minimum of 70 psi when the tool
is being used. An inadequate air supply can
cause a loss of power and inconsistent
driving.
An oiler can be used to provide oil
circulation through the tool. A filter can be
used to remove liquid and solid impurities
which can rust or gum up internal parts of
the tool.
Always use air supply hoses with a minimum
working pressure rating equal to or greater
than the pressure from the power source if a
regulator fails, or 150 psi, whichever is
greater. Use 3/8 in. air hose for runs up to 50
ft. and use a 3/8 in. quick coupler on the air
hose.
Use a pressure regulator on the compressor,
with an operating pressure of 0-125 psi. A
pressure regulator is required to control the
operating pressure of the tool between 70
and 115 psi.
1.
2.
3.
4.
CAUTION:
The air compressor must be able to
maintain a minimum of 70 psi when the
tool is being used. An inadequate air
supply can cause a loss of power and
inconsistent driving.
D o n o t c on n e c t w i t h a n a i r
compressor which can potentially
exceed 200 psi. As tool may burst,
possibly causing injury.
WARNING:
!
Quick
connector
Quick
Coupler
Airhose
Quick
connector
Oiler
Regulator
Filter
Compressor
Quick
Coupler
oil
After adding oil, run tool briefly. Wipe off any
excess oil from the cap exhaust.
3.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents and
maybe damaged by their use. Use clean cloths
to remove dirt, dust , oil, grease, etc.
CLEANING
CAUTION:
Lubricate tool only with specified
lubricants.