: MODEL: SFBC940 GENERAL SAFETY RULES P3 UNPACKING P& FEATURES Pé OPERATION P7 P10 ADJUSTING THE EXHAUST P CHANGING THE NOSE COVER P7 LOADING FASTENERS P8 UNLOADING FASTENERS P8 CLEARING JAMS Pg SETTING THE AIR PRESSURE P9 DEPTH ADJUSTMENT Po ADJUSTING THE FLOORING PLATE P10 FIRING THE TOOL P10 MAINTENANCE P11 RECOMMENDED HOOKUP P12 TROUBLESHOOTING P13 WEARABLE PARTS P13 WARRANTIES P14 A WARNING: The warnings and precautions discussed In this manual cannot cover all possible conditions and situations that m
®Do not use on a ladder or unstable . Stable footing on a dolls surface enables better control of the tool In unexpected situations. ®Make sure the hose Is free of obstructions or snags. Entangled or snared hoses can cuss loss of balance or footing and may become damaged, resulting in possible injury. ® Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations.
Such precautionary measures reduce the risk of injury to persons. LOADING TOOL ®Dc not load the tool with fasteners when any one of the operating controls is activated. @ Never pace a hand or any part of body In fastener discharge area of tool. ® Never point the tool at annoys. @ Do not pull the trigger or depress the workplaces contact as accidental ::tuition may occur, possibly causing Jury.
MODEL: SFBC940 LOADING FASTENERS 1. Conn act the tool to the alr source. . 2.Press down on the magazines latch when bulbnfi.wllblekonflgnm connected to the air source. Always connect the tool to the air source 3. Brad nails: Insert a stick of fasteners into before loading fasteners to proven ‘the magazine Raleigh. Make sure the pointed ends of the fasteners are resting on the bottom edge of the magazine when loading. Make sirs the fasteners are not dirty or damaged.
-Adjustment wheel(J) Flush 7 » " Tum the adjustment knob clockwise NOTE: When uss the tool as a flooring taller, the depth adjustment wheel must be set at the top of the wheel bar. To sot the wheel: 1.Tun the whee! right 1o move the ‘wheel up. 286th the wheel at the top of the wheel. CAUTION: It Is advisable 1o test the depth on a scrap workplace to determine the required depth for the application. To determine depth of drive, first ad lust the alr pressure and dive a test fastener. Over exceed 110 pal.
CAUTION: The work surface can combs damaged by excessive Lubrication. Proper lubrication Is the owner's responsibility. Allure to fabricate the ‘ool properly will dramatically shorten the rife of the tool and wold your warranty. CLEANING Avoid using solvents when cleaning plastic parts. Moat plastics are susceptible to damage from various types of commercial solvents and may be damaged by their uss. Uss clean cloths ta removes dirt, dust , oll, grease, etc.
MODEL: SFBC940 NUMB PGP INC. PRODUCT WARRANTIES NU MAX Pneumatic All Guns Warranties 1 Year Professional Tool Warranty The Nu max Tool limited warranty extends exclusively to the origin purchaser of the Numeral Product, basing on the date of purchase and excludes wearable parts. During the warranty period Prime Global Products, nc. {PGP) expressly warrants that the Nu max Product Is fees from defect in materials and workmanship subject to the exceptions and limitations contained herein.
