MODEL: SFN50 SFN50-V1 03/19
MODEL: SFN50 MODEL: SFN50 GENERAL SAFETY RULES P3 UNPACKING P6 FEATURES P6 SYMBOLS ● The following signal words and meanings are intended to explain the levels of risk associated with this tool, and can be found in the manual, packaging, labeling, and all other information provided with this tool: SYMBOLS OPERATION ADJUSTING THE EXHAUST P7 LOADING FASTENERS P7 UNLOADING FASTENERS P8 CLEARING JAMS P8 NON-MARRING TIP P8 SETTING THE AIR PRESSURE P8 DEPTH ADJUSTMENT P9 FIRING THE TOOL P9
MODEL: SFN50 MODEL: SFN50 Do not use on a ladder or unstable supports. Stable footing on a solid surface enables better control of the tool in unexpected situations. M a k e s u re t h e h o s e i s f re e o f obstructions or snags. Entangled or snarled hoses can cause loss of balance or footing and may become damaged, resulting in possible injury. Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations.
MODEL: SFN50 MODEL: SFN50 Such precautionary measures reduce the risk of injury to persons. FEATURES LOADING TOOL AIR CONSUMPTION: 3.6 SCFM with 100 fasteners per minute @ 90 psi AIR INLET: 1/4 inch NPT MAGAZINE CAPACITY: 80 fasteners, 16 gauge WEIGHT: 2.8 lbs MAXIMUM PRESSURE: 110 psi PRESSURE RANGE: 70 psi – 110 psi FASTENER LENGTH RANGE: 3/4 inch to 2 inch ● Do not load the tool with fasteners when any one of the operating controls is activated.
MODEL: SFN50 MODEL: SFN50 UNLOADING FASTENERS Unloading is the reverse of loading. Always disconnect the air source before unloading. ! WARNING: Always unload all fasteners before removing tool from service. ! WARNING: ! WARNING: Disconnect the tool from the air source whenever clearing a jam. After disconnecting the tool from the air compressor, there should still be enough air pressure to fire the tool.
MODEL: SFN50 MODEL: SFN50 ! CAUTION: Check the operation of the work contact element trip mechanism before each use. The WCE must move freely without binding through its entire travel distance. The WCE spring must return the WCE to its fully extended position after being depressed. Do not operate the tool if the WCE trip mechanism is not operating properly. Personal injury may occur. ! Any time inspection, maintenance, and cleaning are going to be carried out: ◆Disconnect the tool from the air source.
MODEL: SFN50 MODEL: SFN50 ! WARNING: Stop using tool immediately if any of the following problems occur. Serious personal injury could result. Any repairs or replacements must be done by a qualified service person or an authorized service center. PROBLEMS POSSIBLE CAUSE(S) CORRECTIVE ACTION Air leaking at trigger valve area. O-rings in trigger valve housing are damaged. Replace O-rings. Check operation of Work Contact Element(WCE). Air leaking between housing and nose. 1.Loose screws in housing.
