User Manual

Performance specification and parameters
Model Specification Rated voltage Rated
frequency
Rated
power
Noise level
OT-FH-2000T Φ91*448mm 220-240V~ 50/60Hz 2000W ≤50dB(A)
How to use
I. Remote control
Use a remote control (each button on the remote control is the same as on your product):
First open the power switch on the back of the machine before use, the machine will sound
an alarm while the power indicator is lit and the temperature is displayed on the control
panel.
1. ON/OFF:
When this key is pressed, the fan starts at a low speed; when the key is pressed again, the
fan stops. (Note: If the heating function is switched on, the switch-off is delayed by 30
seconds.)
2. HEATER:
Press this button once for the low fan speed and twice for the higher fan speed
Press again to stop the heating function.
3. SET TEMP:
When this button is pressed, the temperature increases by 1 degree Celsius. The settings
start at 15 degrees and end at 45 degrees. If you press the button again after reaching the
maximum, you will return to the 15 degree minimum. (Note: If the ambient temperature is
higher than the set temperature, the heating function will not work. If the set temperature is
2 degrees above the ambient temperature, the heating function will start to work properly.
4. SWING:
When this button is pressed, the oscillation function starts and the fan starts running. When
the button is pressed again, the fan stops. This ensures proper circulation of the warm air.
5. TIMER:
When the heater is in operation and this button is pressed, it switches to the time status.
The setting at this time is 1 hour. The timing can be selected between 1h and 12h. If the
timer is set to 12h and this button is pressed again, the timer will abort.
Die Timing-Stunden ändern sich gemäß der folgenden Darstellung: