User's Manual

2 Device Features and Specifications
Feature Details
Location Technology
GPS / AFLT / RF
Battery Life
30 Hours
Charging Time
~90 Minutes
Weight Total
8.4 oz.
Waterproof
IP67 Rated for 1 Meter Depth
Memory
Stores 10 Days of Data
Offender Communication
Sends Vibrate & Tone
Offender Response
Single Button for Acknowledgement
3 Device Set-Up
3.1 Charging Your Device
Before you install and use the device it will be necessary to charge the battery:
Step 1: If not already connected, attach the device adapter into the wall adapter.
Step 2: Then, plug the fully assembled device into the device charger for 3 hours. After 3 hours, the LED
should be green indicating a full charge.
Step 3: After charging, remove the device from the charger, and unplug the charger from the wall outlet.
3.2 Setting Up Your Device in the FocalPoint® Offender Monitoring™
Application
You must log into FocalPoint and complete two essential and two optional steps before you install the
device:
Step 1: Assign a rate plan to the device (i.e. the frequency the device should be located)
Step 2: Assign an offender to the device
Step 3: (Optional) Assign Zones and Schedules for the Offender & Device
Step 4: (Optional) Assign a RF Beacon to the device and assign a home zone for the beacon
You can locate instructions for completing these tasks by navigating to FocalPoint’s Help center, located
in the bottom, left-hand corner of the FocalPoint website’s screen.
3.3 Installing Your Device on an Offender
Ensure the device is fully charged and turned on.
You will be installing the device on an individual’s leg. Have that individual stand facing a chair, with the
installation leg bent, shin resting on the chair seat, with the foot pointing behind them. Alternatively,
have the individual sit in a chair with their installation leg propped up in front of them, on a desk or
other flat surface.
Step 1: You must disassemble the device, separating device components before you can install the
device on an ankle. Remove the top pin from the device entirely by pulling the pin upwards. Remove the