User's Manual

Step 2: Select the beacon device number you wish to assign to the OM400 and select “Assign”
Step 3: Choose the zone you would like to assign to this beacon from the zone selection page
7 Important Safety Information and Regulatory Notices
Interference
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1) l’appareil ne doit pas produire de brouillage, et
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le onctionnement.
Modifications
Changes or modifications made to this equipment not expressly approved by Omnilink® may void the FCC
authorization to operate this equipment.
Radio Frequency (RF) Exposure
This ankle worn radio device has been evaluated and found to be compliant with the requirements as set
forth in FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields. This device is to
be used solely by law enforcement agencies for tracking purposes and must be professionally installed.
The average radiation output power of this device falls below the FCC radio frequency exposure limits.
The user must be informed that this device emits RF energy and found to comply with all health and
welfare agencies.
This device is intended for body worn operation. This device has been tested and meets the FCC RF
exposure guidelines when used with the strap accessory supplied by Omnilink and designated for this
product. Use of other accessories is not recommended and may not ensure compliance with FCC RF
exposure guidelines.
8 Contacting Omnilink®
For questions regarding Technical Issues, contact:
Omnilink Technical Support