User's Manual

Manually Overriding the Security System

If your transmitter is lost or disabled, it will be necessary use the emergency

override button to turn the security system off. There are two types of

emergency override procedures. Check with your installing dealer to find out

what has been activated on your system.

Standard Emergency Override Procedure:

1. Open the vehicle door. The alarm will sound.

2. Turn the ignition key to the ON position.

3. Within 5 seconds, press and release the valet button.

The alarm system will stop sounding and enter the (by-passed) mode. You can

now start and operate the vehicle normally.

2 Car Mode

It is possible for your remote transmitter to control 2 vehicles provided the both

are equipped with compatible security or remote start systems and your

transmitter has been programmed to the additional vehicle’s system. To operate

the additional vehicle you must first enter 2 car mode from the remote control.

Once in 2 car mode, the remote control will operate only the second vehicle, the

original vehicle will have no response from the remote. To enter or exit 2 car

mode, refer to the transmitters advanced functions menu section of this manual.

Valet Mode

To engage valet mode:

1. Turn the ignition key to the ON position.

2. Press and hold the valet button for 5 seconds.

3. The LED will light solid indicating that the system is in valet mode.

When valet mode is activated the status LED will light solid, and all security

functions will be disabled.

To disengage valet mode:

1. Turn the ignition key to the ON position.

2. Press and release the valet button.

3. The LED will turn off indicating that the system has exited valet mode.