User's Manual

128-9309

17 of 24

Page 17

Triggered and entry attempt was made to the vehicles glass, or the ve-

hicle has been hit or bumped hard enough to cause a response from the

vibration detector.

ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:

If the arm/disarm chirp tones have been turned off at the

vehicle, when you arm, or disarm, the display will indicate this as shown

and there will be no arm/disarm chirps at the transmitter. This is true if the

transmitter is set for vibrate mode as well.

When the vehicle is armed, and a door is opened, or ajar, the transmitter will

chirp 3 times, the lights will ash, and the display will indicate a door trigger as

shown above. When the door is closed or the zone clears, the transmitter will

chirp 1 time, and the display will clear.

When the vehicle is armed, and the hood or trunk, is opened or ajar, the trans-

mitter will chirp 3 times, the lights will ash, and the display will indicate a hood

or trunk trigger as shown on the previous page. When the hood or trunk is

closed, or the zone clears, the transmitter will chirp 1 time, and the display will

clear.

PROGRAMMED TRANSMITTER NOTIFICATION (PTN)

Every time after Disarm when the ignition key is turned on, the unit's LED will

report the number of transmitters programmed into the system. This safety

feature will alert you if an unauthorized transmitter has been programmed into

your vehicle's security system without your knowledge. Typical from the factory,

there will be a 2 ash, pause, repeated 3 times indicating that two transmitters

are programmed into the system. If you note additional ashes, there may have

been an additional transmitter added without your knowledge or authorization. If

you notice a change in the transmitter LED report pattern, you can correct this by

looking up how to erase and reprogram your transmitters found in the transmit-

ter programming guide. This reprogram operation will erase all unauthorized or

unwanted transmitters.