User's Manual

128-9319

4 of 2

FCC COMPLIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that may

cause undesired operation.

Warning!

Changes or modications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment

NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modications to

this equipment. Such modications could void the user’s authority to operate the equipment

PROGRAMMED TRANSMITTER NOTIFICATION (PTN)

Every time after Disarm, when the ignition key is turned on, the unit's LED will report the

number of transmitters programmed into the system. This safety feature will alert you if an

unauthorized transmitter has been programmed into your vehicle's security system without

your knowledge. Typically from the factory, there will be 2 ashes and a pause, repeated

3 times, indicating that two transmitters are programmed into the system. If you note addi-

tional ashes, an additional transmitter may have been added without your knowledge or

authorization. If you notice a change in the transmitter LED report pattern, you can correct

this by looking up how to erase and reprogram your transmitters found in the transmitter

programming guide. This reprogram operation will erase all unauthorized or unwanted

transmitters.

Transmitter Battery Replacement:

1) Locate and remove the "00" point philips head screw on the back of the transmitter

case.

2) Carefully separate the front case from the rear.

3) Slide the CR2032 battery out from under the battery clip and dispose of properly.

4) Install the new battery with the (+) side facing up away from the circuit board.

5) Close the case and reassemble in reverse of disassembly

FUNCTION SETTING CHART

To be completed by installer

Run Time _____Min 

Door Lock Timer ______Sec 

Lights Pulse  Steady 

To purchase replacement transmitters or to get additional product

information go to: www.pursuitcarsecurity.com