User's Manual

128-9307
14 of 16
Page 14
To purchase replacement transmitters
or to get additional product information go to:
www.pursuitcarsecurity.com
Note: Certain systems have the ability to utilize channels 6 and 7 for driver priority
programming. For driver priority, the vehicle must be equipped with this feature,
and the optional feature must be set up and installed by your installation center.
Once this feature is added when the unlock button of transmitter 1 is used, it will set
driver 1 priority and when the unlock button of transmitter 2 is used it will set driver
2 priority. In this situation, the unlock button can be programmed into two receiver
channels, unlock, channel 2 and driver priority 6 or 7. In no other circumstance will
the system allow a transmitter button to be programmed into 2 receiver channels
at the same time.
This remote has the ability to operate 2 similar Alarms From A Single
Transmitter. To toggle on and off vehicle one or two,,,
Press the Trunk/Key button + the Lock button for 5 seconds.
The LED ashes 2 times. Release the buttons, to select 2nd vehicle mode.
Program this transmitter into the second vehicle's system. Any time you
are in 2nd vehicle when the transmitter is operated, the LED will ash twice for
each function. When in in the prime vehicle mode, the LED will ash once for each
function.
Transmitter Battery Replacement
1) Remove the 00 philips head screw from the rear case.
2) Separate the case halves by inserting a small plastic tool in the top right slot.
3) Carefully slide the CR2032 battery out from under the battery clip and dispose
of properly.
4) Insert a fresh CR2032 battery with the (+) side up away from the PCB.
5) Close the case in reverse of disassembly.
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that may
cause undesired operation.
Warning!
Changes or modications not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment
NOTE:The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modications to this equipment. Such modications could void the users
authority to operate the equipment