User's Manual
128-9307
5 of 16
Page 5
Any mild impact to the vehicle’s glass will cause the alarm to sound a short
series of warning tones.
Any strong impact to the vehicle’s glass will cause the alarm to trigger for the
full 30 second alarm cycle.
NOTE: If the optional interior illumination circuit was installed, the interior light will
ash as well for the full 30 second alarm cycle.
DISARMING THE SYSTEM
As you approach the vehicle, press and release the Disarm button on the keychain
transmitter.
The parking lights will ash two times, the siren will chirp twice, and the dash mounted
LED will turn off.
If you have the optional door lock/unlock circuit installed, the doors will unlock. If you
have the optional entry illumination circuit installed, the interior light will turn on for 30
seconds or until the ignition key is switched on.
NOTE: If the passive arming mode was selected at time of installation, the dash mounted
LED will start ashing rapidly indicating that the system is rearming. Opening any
door will suspend the automatic arming.
If the parking lights ashed three times, and the siren chirps four times, this indicates
that the alarm system was triggered during your absence. Before turning on the ignition
key, examine the dash mounted LED's ash pattern. The number of ashes identies
the triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS
found later in this manual.
If the siren did not sound upon disarm, then the chirps have been turned off. Refer to
the section titled ELIMINATING THE ARM/DISARM CHIRPS.
NOTE: If the optional 2 step door unlock circuit is installed, when the unlock transmitter
button is activated, the drivers door only will unlock, pressing the unlock button a
second time will cause all doors to unlock. If your transmitter has a sperate lock
unlock buttons, pressing the unlock button anytime after the rst unlock command
will cause all the vehicle doors to unlock.
SILENT DISARMING (Feature must be activated during programming)
During step 1 above, hold the transmitter button for 2 seconds then release. The
unit will arm without the chirps for this one lock cycle.
WHILE THE SYSTEM IS SOUNDING
If during a triggered state, you wish to shut off the siren without disarming your security
system, simply press and release any transmitter button other than the disarm button.
This action will turn off the siren yet leave the vehicle fully armed and protected. This
feature is particularly useful if you are aware of children playing near your vehicle that may
accidently trigger your security system. In this case you can cancel the siren sounding.
INTRUSION WARNING SIGNAL
This system will inform you if an intrusion attempt has occurred while you were away