User's Manual

ManualsBrandsNutek ManualsElectronicsTransmitter

128-9446

1 of 12

Page 1

APS-687TWE

Owners Guide

Deluxe 7 Channel LED

Remote Start System

With Keyless Entry

PATENTED: www.voxxintlcorp.com/company/patents

FCC COMPLIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that may

cause undesired operation.

Warning!

Changes or modications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment

NOTE: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modications to this equipment. Such modications could void the

user’s authority to operate the equipment

Table Of Contents:

Features and Options Page 2

Your "Spread Spectrum" Transmitters Page 3

Keyless Entry Page 3 - 4

Optional Remote Function Channels Page 4

Optional Additional Remote Channel 4 Page 4

Optional Additional Remote Channel 5, 6, 7 Page 5

Valet Override, Programming & Safety Control Switch Page 6

Vehicle Service / Remote Start Override Mode Page 6

Turbo Timer Operation Page 6 - 7

Remote Starting The Vehicle Page 7 - 8

Automatic Start Timer Operation Page 9 - 10

Telematic Upgrade Page 10

Programmed Transmitter Notication (PTN) Page 10

Programming New or Replacement Transmitters Page 11

Features And Function Setting Chart Page 12

FCC COMPLIANCE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Warning!

Changes or modifications not expressly approved by the part responsible for compliance could void the use's authority to operate the equipment

NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this

equipment. Such modifications could void the user's authority to operate the equipment.

PATENTED: www.voxxintlcorp.com/company/patents

Summary of content (12 pages)

PAGE 1
APS-687TWE Owners Guide Deluxe 7 Channel LED Remote Start System With Keyless Entry Table Of Contents: Features and Options Page 2 Your "Spread Spectrum" Transmitters Page 3 Keyless Entry Page 3 - 4 Optional Remote Function Channels Page 4 Optional Additional Remote Channel 4 Page 4 Optional Additional Remote Channel 5, 6, 7 Page 5 Valet Override, Programming & Safety Control Switch Page 6 Vehicle Service / Remote Start Override Mode Page 6 Turbo Timer Operation Page 6 - 7 Remote Starting
PAGE 2
Deluxe 7 Channel LED Remote Start System With Keyless Entry FEATURES :  1 Five Button LED Programmable RF Transmitters  1 Five Button Programmable RF Transmitters  Seven Channel Receiver (capable of accepting 4 transmitters)  Code Hopping Technology  External Superheterodyne Antenna w/PushButton Switch and LED  Safe Start RF Control (Double Push Of RF Transmitter)  Selectable Automatic Timed Start Mode  Keyless Entry Outputs (-)  On-Board Start Relay  On-Board Accessory Relay  3 On-Board Igniti
PAGE 3
YOUR “SPREAD SPRECTUM" TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s 1 2 sophisticated auto thieves use a device known as a 1 2 code grabber, which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system.
PAGE 4
once when the doors are locked and twice when the door are unlocked. If the optional illuminated entry feature has been added, the interior light will turn on when the doors are unlocked and remain on for 30 seconds or until the ignition is turned on. Holding the lock/unlock transmitter button for 3 seconds will activate the car finder mode causing the parking lights to flash and the optional horn to beep for 30 seconds Activating these button's a second time for 3 seconds.
PAGE 5
 Right Or Left Slider Doors in An Equipped Van To activate the optional accessory, press the option button on the keychain transmitter. The optional accessory will immediately engage. ADDITIONAL REMOTE FUNCTION (CHANNEL 5) This system has an additional feature that can be connected to a number of different optional accessories.
PAGE 6
To activate the optional accessory, press the option button on the keychain transmitter. The optional accessory will immediately engage. Note: If your system utilizes the transmitter shown, the second option button may be configured to operate additional accessories. Please consult your installing retailer for more information concerning the options available.
PAGE 7
and how long the vehicle will continue to run, 3, 5, or 10 minutes after the ignition switch is turned off. TO ACTIVATE THE TURBO TIMER Anytime the ignition key is in the on position for more than 15 seconds: 1) Place the gear selector in park. 2) Set the parking, (hand), brake. 3) Be certain your foot is off the brake pedal. 4) Press the receiver's program/Push-Button switch 2 times within 5 seconds. The parking lights will flash two times indicating the mode was successfully entered.
PAGE 8
WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if the car is garaged. TO REMOTE START THE VEHICLE Press and release the trunk/key button of your keychain transmitter two times within 2 seconds. The vehicle will start and remain running for the pre-programmed time selected.
PAGE 9
OPERATING ON AUTOMATIC START UP TIMER MODE The system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine. WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device.
PAGE 10
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. CANCELING THE AUTOMATIC START UP TIMER To cancel the automatic start up timer do one of the following; 1. Start the vehicle manually with the use of the ignition key and depress the brake pedal. 2. Remote start the vehicle using your keychain RF transmitter. 3. Shut off the vehicle using the keychain transmitter by pressing and releasing the trunk/key transmitter button 2 times.
PAGE 11
Programming New Or Replacement Transmitters (BANK 1) Transmitter Model Name Are Found On Back Of The Transmitter Case. Batteries CR2032 Are Also Indicated There 1) Turn the ignition key to the on position. 2) Press and release the valet/programming switch 3 times (Horn Beeps). 3) P ress the Lock Button of each transmitter you want programmed until you hear a chirp from the horn or the parking lights flash. 4) Turn the ignition switch off.
PAGE 12
circumstance will the system allow a transmitter button to be programmed into 2 receiver channels at the same time. This remote has the ability to operate 2 Prestige Alarms From A Single Transmitter. To toggle on and off vehicle one or two,,, Press the Trunk/Key button + the Lock button for 5 seconds. The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode. Program this transmitter into the second vehicle's system.