User's Manual

128-6799D

8 of 8

128-6799D

FCC COMPLIANCE

is device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) is device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. ese limits are designed to provide reasonable protection against harmful interference in a

residential installation. is equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment o and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Warning!

Changes or modications made to this equipment not expressly approved by the part responsible for compliance

could void the use’s authority to operate the equipment

NOTE: e manufacturer is not responsible for any radio or TV interference caused by unauthorized modica-

tions to this

equipment. Such modications could void the user’s authority to operate the equipment.