User Manual

User Programmable Features (cont’d)
This group of Installer Programmable Features are all accessed as a group in the second level of
features’ programming. These features have a direct affect upon the system’s operations related
to the installation and vehicle type AND SHOULD ONLY BE CHANGED BY THE INSTALLER!!!
Feature #1 - Remote Start Activation From The WHITE/BLUE Wire
1 pulse (press “start” 1 time to program) - DEFAULT
2 pulses (press “start” 2 times to program)
3 pulses (press “start” 3 times to program)
4 pulses (press “start” 4 times to programm)
This feature changes how the remote start feature is activated from the (-) activation input wire.
Feature #2 - PINK/WHITE (IGN #2)Wire Function
Ignition (press “start” 1 time to program) - DEFAULT
Accessory (press “start” 2 times to program)
Starter (press “start” 3 times to program)
This feature changes the operation of the unit’s large PINK/WHITE output wire. This feature
should only be programmed by the installer.
Feature #3 - Engine Detection Method
Tachless Hi (press “start” 1 time to program) - DEFAULT
Tachless Lo (press “start” 2 times to program)
Tach Wire (press “start” 3 times to program)
Data Tach (press “start” 4 times to program)
Crank Only (press “start” 5 times to program)
This feature selects the method in which the remote start monitors the engine’s running condition
in remote start mode.
“Tachless Hi” sensitivity mode uses a preset crank time (see installer feature #7) and monitors
the vehicle’s voltage level to determine if the engine is running. This setting looks for a voltage
increase of 0.3v after cranking.
“Tachless Lo” sensitivity mode operates like the “Tachless Hi” setting but looks for a voltage
increase of 0.5v after cranking.
“Tach Wire” Before this setting is programmed, refer to the “Violet/White wire” section of the
installation manual for proper wiring connection and the Tach Learn Procedure. It will crank the
engine for up to 3 seconds or until a tach signal is detected.
Feature #11 - Conrmation Chirps
Siren + Horn (press “start” 1 time to program)
Siren Only (press “start” 2 times to program) - DEFAULT
On Demand (siren+horn) (press “start” 3 times to program)
Off (press “start” 4 times to program)
This feature selects whether the siren and/or horn give conrmation chirps. Both
outputs will always sound when the alarm system is triggered or in panic mode.
NOTE: Both the siren and horn outputs must be connected for this feature to function.
Feature #12 - Anti-Carjacking
Ignition Only (press “start” 1 time to program)
Door Only (press “start” 2 times to program)
Ignition + Door (press “start” 3 times to program)
Off (press “start” 4 times to program) - DEFAULT
This selects between the 2 forms of anti-carjacking protection. Details on using anti-
carjacking protection are described on page 7.
Installer Programmable Features
10