User Manual

Installer Programmable Features (cont’d)
Feature #14 - Pulse Ignition On Disarm
On (press “start” 1 time to program)
Off (press “start” 2 times to program) - DEFAULT
This feature will pulse the ignition and activate any attached immobilizer bypass module for
vehicles that require the ignition to be turned on to disarm the OEM alarm.
Feature #15 Lock On Prewarn
On (press “start” 1 time to program) - DEFAULT
Off (press “start” 2 times to program)
This feature will automatically lock the doors to combat unauthorized entry from lock picking when
the prewarn zone is triggered.
Feature #16 - Starter Interrupt Output Functions (EDP+ Models Only)
Alarm Only (press “start” 1 time to program)
Anti-Grind Only (press “start” 2 times to program) - DEFAULT
Alarm & Anti-Grind (press “start” 3 times to program)
Automatic (press “start” 4 times to program)
Alarm Only - The Starter Interrupt is operable whenever the alarm is armed.
Anti-Grind Only - The Starter Interrupt is operable whenever remote start is on.
Alarm & Anti-Grind - This setting engages starter interrupt when the alarm is armed AND when
the system is in remote start mode. This prevents the starter from grinding if the user accidentally
turns the key to “START” during remote start.
Automatic - This will cause the Starter Interrupt output to automatically engage 90 seconds after
the ignition switch is turned “off”, and after disarming the system.
Feature #17 Low Temp Crank Extender (EDP+ Models Only)
0ms (Off) (press “start” 1 time to program)
200ms (press “start” 2 times to program) - DEFAULT
300ms (press “start” 3 times to program)
400ms (press “start” 4 times to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra crank time to the
base timing (see installer feature #7). It applies to tachless modes only (installer feature #3).
13