User Manual

LOCK / ARM: While the system is unlocked / disarmed, Press

and hold the “START” button for 1 second.

• THE SIREN / HORN WILL CHIRP & THE PARKING

LIGHTS WILL FLASH ONCE.

• 2-WAY RESPONSE: CONTROLLER WILL BEEP ONCE

AND THE BUTTON WILL FLASH ONCE.

Transmitter Functions

UNLOCK / DISARM: While the system is locked / armed, Press

and hold the “START” button for 1 second.

• THE SIREN / HORN WILL CHIRP TWICE & THE

PARKING LIGHTS WILL FLASH TWICE, THEN ILLUMINATE

FOR 30 SECONDS.

• 2-WAY RESPONSE: CONTROLLER WILL BEEP TWICE

AND THE BUTTON WILL FLASH TWICE.

REMOTE START: Press and release the “START” button twice

within 5 seconds. (see user feature #8 for additional options)

• THE PARKING LIGHTS WILL FLASH ONCE & THE STATUS LIGHT

WILL FLASH RAPIDLY.

• 2-WAY RESPONSE: THE CONTROLLER WILL PLAY A MELODY.

• THE SYSTEM WILL PROCEED TO START THE ENGINE.

• ONCE THE ENGINE IS RUNNING, THE PARKING LIGHTS WILL FLASH

EVERY 1.5 SECONDS & THE STATUS LIGHTS WILL FLASH SLOWLY.

• 2-WAY RESPONSE: THE CONTROLLER BUTTON WILL FLASH ONCE

EVERY 2 SECONDS.

• If the engine stalls, the system will make up to 3 more attempts.

• Each time you park, set the climate controls as desired when you use the remote start. The

engine will run for the preset run time (see user feature #1).

• Run Time Expiration Warning (2-way models only): The controller will beep once when 1

minute remains in remote start cycle.

• Run Time Extender: Press the “START” button one time during remote start to restart the

engine run timer.

NOTE: This can only be used once per remote start cycle.

• If you decide not to drive your vehicle, you can turn off the remote start using the same method

to turn it on (Default = press “START” twice in 5 seconds)

NOTE: If remote start activation is programmed for 1 press, the 1st press activates Run

Time Extender so an additional press is required to turn off remote start.

• Upon entering the vehicle during remote start mode, turn the ignition key to the “ON/RUN” posi-

tion (NOT START!!). When you press the brake pedal, the remote start will turn off,

allowing the ignition key to take over.