User's Manual

ManualsBrandsNutek ManualsElectronicsWater Sensor

WS-LD

water Sensor

Item 001

Identifying the Parts:

1. Antenna

2. Learn I Test Button

3. Probe (Water Detection)

4. Battery Lid

5. Buzzer

Accessories:

1 Probe cable

1 Set of mounting screws

1 Battery

Getting Started

Remove battery lid by sliding it the direction of the arrow

on the bottom of the water sensor.

Pull battery clip out and connect to battery then re-insert into

the water sensor.

* Programming Sensor to Receiving Devices:

Put the receiving device in to Learning mode (see

instruction for your particular receiving device). Press Red

Button on Sensor being learned. If additional sensors need

to be learned press Red button on next device.

Page 1

XT.MExbufstfotpsnbovbm/qeg!!!2XT.MExbufstfotpsnbovbm/qeg!!!2 312105026!!!Πϱ!14;42;3:312105026!!!Πϱ!14;42;3:

Summary of content (5 pages)

PAGE 1
WS-LD water Sensor ˄ 5 Ϥ Ϥ 2 Ϥ Item 001 Identifying the Parts: 1. Antenna 2. Learn I Test Button 3. Probe (Water Detection) 4. Battery Lid 4 Ϥ 5. Buzzer 3 Ϥ Accessories: 1 Probe cable 1 Set of mounting screws 1 Battery Getting Started . Remove battery lid by sliding it the direction of the arrow on the bottom of the water sensor. . Pull battery clip out and connect to battery then re-insert into the water sensor.
PAGE 2
Programming the Water Sensor directly to a Motorized Valve Control Unit: . Enter VCU's in to learning mode by holding the red button Located on the bottom panel for 5 seconds. A short beep will sound release the button, the VCU will sound a long beep and the LED will turn on. Now on the Sensor press the Red Button, two beeps indicate Successful learning. Press VCU's red button to exit Learning mode. Positioning the Water Sensor in place on level surface or wall Mount using the provided screws. .
PAGE 3
. Normal Operation: . When the probe touches water, the sensor will sound an alarm and send a signal to a receiving device. If the signal is sent to a VCU unit, it will close the valve. Sensor will continue alert until the probe is dry. Sensor can be reset or alarm silenced by pressing the Red Button. For FCC Compliance NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted.
PAGE 4
Limited Warranty Condoplex warrants it’s products for a period of two years from the date of purchase, this product will be free from defects in material and workmanship. Condoplex at its option will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component.
PAGE 5
FCC ID : ELVNTJD This device complies with FCC Rules Part 15 Operation is subject to the following two conditions (1) This device may not cause harmful interference and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user ’s authority to operate the equipment.