User's Manual

Programming the Water Sensor directly to a Motorized Valve
Control Unit:
. Enter VCU's in to learning mode by holding the red button
Located on the
bottom panel for 5 seconds. A short beep will sound
release the button, the VCU will sound a long beep and the LED will
turn on.
. Now on the Sensor press the Red Button, two beeps indicate
Successful learning. Press VCU's red button to exit Learning mode.
Positioning the Water Sensor
in place on level surface or wall
Mount using the provided screws.
* Probe Extender may be used to monitor hard-to-reach places.
Or when the unit is mounted high up on the wall, or when a pad
is required to cover a larger radius space.
To activate the extender, insert probe extender plug into the
socket on the Sensor's probe and mount using the screws
provided
ʳ
Page 2
XT.MExbufstfotpsnbovbm/qeg!!!3XT.MExbufstfotpsnbovbm/qeg!!!3 312105026!!!Πϱ!14;42;55312105026!!!Πϱ!14;42;55