User's Manual

Table Of Contents

Controller Functions (cont’d)

TRUNK RELEASE / CHANNEL 2: Press the LOCK & START buttons

for 3 seconds�

• THE SYSTEM WILL UNLOCK/DISARM AND THE TRUNK

WILL OPEN (IF EQUIPPED)�

1-BUTTON REMOTE: NOT AVAILABLE

REMOTE START: Press and release the START button twice within 5

seconds (see user feature #8 to change)�

• THE PARKING LIGHTS WILL FLASH ONCE AND THE

STATUS LIGHT WILL FLASH RAPIDLY�

• THE SYSTEM WILL PROCEED TO START THE ENGINE�

• ONCE THE ENGINE IS RUNNING, THE PARKING LIGHTS

WILL TURN ON AND THE STATUS LIGHT WILL FLASH

SLOWLY�

• If the engine stalls, the system will make up to 3 more attempts�

• Each time you park, set the climate controls to give you the desired interior

temperature when you use the remote start�

• The engine will run for the preset run time (see user feature #1)�

• Run Time Extender: Press the START button one time during remote start to

restart the engine run timer� The timer will restart�

NOTE: This can only be used once per remote start cycle.

• If you decide not to drive your vehicle, you can turn off the remote start using the

same method to turn it on (Default = press START twice in 5 seconds)�

NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so an

additional press is required.

• Upon entering the vehicle during remote start mode, turn the ignition key to the

“ON/RUN” position (NOT START!!)� When you press the brake pedal, the remote

start will turn off allowing the ignition key to take over�