SDS

however, due to their insolubility, relatively low toxicity and small amount present in the phosphor and lamp, these
materials do not present a significant hazard in the event of breakage of the lamp.
Glass: Glass dust is considered to be physiologically inert and as such has an OSHA exposure limit of 15-mg/cubic meter
for total dust and 5-mg/cubic meter for respirable dust. Perform normal first aid procedures. Seek medical attention as
required.
Inhalation: If discomfort, irritation of symptoms of pulmonary involvement should develop, remove from exposure and
seek medical attention.
Ingestion: In the unlikely event of ingestion of a large quantity of material, seek medical attention.
Eye/Skin Contact: Wash eyes/skin, including under eyelids, immediately with copious amounts of water and seek
medical attention.
Section 7. HANDLING AND STORAGE
Use good material handling and storage practices to avoid breakage. Take usual precautions for collection of broken
glass. Place materials in closed containers to avoid generating dust. All compact fluorescent lamps contain some
amount of mercury. The EPA recommends that if a CFL breaks carefully sweep up all the fragments—wipe the area with
a wet towel and dispose of all fragments, including the used towel, in a sealed plastic bag. Follow all disposal
instructions. If possible open windows to allow the room to ventilate. Do NOT use a vacuum. Place all fragments in a
sealed plastic bag and follow disposal instructions. All disposal options should be evaluated with respect to federal,
state, and local laws and requirements. Before disposing check with officials for current CFL disposal regulations.
Section 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
If lamp breaks, sharp edges and dust can be created. Wear eye protection, gloves, and respiratory protection when
cleaning up breakage. Contain in closed container and dispose based on applicable Federal, State, and local
regulations.
Ventilation: Avoid prolonged exposure through the use of adequate ventilation during clean up or disposal.
Respiratory: Use NIOSH approved respirator if large quantities of lamps are being broken for disposal
Hand and Eye Protection: OSHA specified safety glasses, goggles, or face shield and puncture resistant gloves are
recommended if lamps are being broken
Section 9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Solid, white
Upper/lower flammability or explosive limits: NA
Odor: None
Vapor Pressure: 0
Odor Threshold: NA
Vapor Density: 0
pH: NA
Relative Density: NA
Melting Point: ~500C
Solubility: Insoluble
Section 10. STABILITY AND REACTIVITY
Reactivity: NA
Chemical Stability: Stable
Section 11. TOXICOLOGICAL INFORMATION
Mercury (Hg) is less than 0.025% by weight.
Carcinogenicity: Some components within the power supply of the LED LAMP may contain carcinogens listed by IARC,
but these quantities typically are well below 0.1% of the total product weight.
Section 12. ECOLOGICAL INFORMATION
NA
Section 13. DISPOSAL CONSIDERATIONS
The EPA recommends that if a CFL breaks carefully sweep up all the fragments—wipe the area with a wet towel and
dispose of all fragments, including the used towel, in a sealed plastic bag. Follow all disposal instructions. If possible open
windows to allow the room to ventilate. Do NOT use a vacuum. Place all fragments in a sealed plastic bag and follow
disposal instructions.
Section 14. TRANSPORT INFORMATION
This material is not classified as a hazardous material or dangerous good by the U.S. Department of Transportation, the
International Air Transport Association, or the International Civil Aviation Organization.