Installation Guide

INSTALLATION AND USE & CARE INSTRUCTIONS

INSTALLATION

5. Connect 4-in. round duct.

6. Connect wiring.

Bend tab to expose desired access hole. Connect

power cable to housing with appropriate UL approved

connector. Connect wires per diagram on page 8. Re-

install wiring panel and secure with screw from parts

bag.

3. Attach damper/duct connector

to fan housing.

Push connector through opening from inside of housing.

Engage tabs and secure with screw from parts bag.

4. Mount housing to ceiling

structure.

TABS

Make sure bottom of housing will be flush with finished

ceiling.

For proper location using ½-inch ceiling material: Bend

out housing tabs to fit against bottom of structure.

Secure housing through mounting ears with

appropriate fasteners.

If mounting housing to I-joist, use wood blocking as

shown.

NEW CONSTRUCTION

For Retrofit Installation - Skip to Page 6.

HOUSING

TABS