Installation Guide

INSTALLATION MANUAL
INSTALLATION
15
HORIZONTAL EXHAUST INSTALLATION
VERTICAL EXHAUST INSTALLATION
OTE: N The following procedure applies to both frame or frameless cabinet installations.
Install the Hood (EZ1 Brackets)
1 ] Run house power cable between service panel and hood location.
2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,
on front C and D on illustration below); these holes allow the range hood to hang on the
brackets (previously installed).
3 ] Temporarily hang the hood on the brackets using its (2) recessed REAR HOLES (A and B).
While holding the hood, run the house power cable into the hood through the strain relief
previously installed in step 6 on page 10.
4 ] Unhook the rear holes from the brackets and hang the hood using its (2) recessed FRONT
HOLES (C and D). Attach power cable to the hood using the strain relief.
5 ] Hang the hood on the brackets using the (2) recessed FRONT HOLES (C and D). Attach
power cable to the hood using the strain relief previously installed in step 6 on page 10.
A
B
C
D
A
B
DUCTED INSTALLATION ONLY
6 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.
Make sure the damper assembly (or round duct plate) enters the ductwork and that the
damper opens and closes freely.