Use and Care Manual

ManualsBrandsNuTone ManualsAppliance partsInlet Mounting Plate for NuTone Central Vacuums

INSTALLATION IN NEW CONSTRUCTION (CONT'D)

CI390 ELECTRAVALVE™

ELECTRIFIED INLET INSTALLATION

(CI395RK ROUGH-IN)

B Refer to top figure at right. Fasten the mounting plate to a stud

within three studs (48") of an electrical outlet box. Measure

and mark the wire 10" from the plug (A). Feed the wire

through the top hole in the mounting plate (just above the

circular opening). Snap the molded plug into the mounting

plate as pictured (B). This will keep it secure and out of

harm’s way during drywalling and finishing. Line up the wire

at the previously measured 10" mark with the strain of relief

channel on the back of the mounting plate. Secure it in place

with the supplied wire tie (C).

C Refer to top figure at right. Run the inlet wire to the adjacent

electric box. If you must run wire through a stud, drill directly

through the center of the stud (D).

D Refer to bottom figure at right. Place the exposed ends of

the two wires into the electrical box through a strain relief

channel (E). Tighten the strain relief channel (do not

overtighten) on the white sheathing leaving 1⁄2" of this

sheathing exposed inside of the outlet box. Fold the 6" of

BLACK and WHITE wire into the outlet box. Leave the wires

to be connected by the electrician when plug receptacles

are being installed.

E Once drywall and finishing processes have been completed,

remove molded plug from mounting plate (with the aid of a

slot screwdriver) and snap it into the wing slot at the back of

the inlet (F).

NOTE: molded plug fits one way only, with the narrow

opening at the top.

Insert inlet into the mounting plate and secure inlet to

mounting plate with screws provided.

NOTE: All electrical devices such as the electrified inlet should

be reported to the construction electrician for listing on

the inspection report for building inspection purposes.

NOTE: Plumb inlet to tubing using NuTone Model CF382S

90° ELL fitting.

CAUTION

Power tools such as routers are not recommended

for use with the inlet installation, as removal of

drywall with these devices may cause damage to

the mounting plate and/or inlet plug.

WARNING

All location and installation direct connect

electrified wall valves must conform with all local

and municipal building codes.

AE0038A

AE0039