Installation Guide

ManualsBrandsNuTone ManualsKitchenHugger Series 52 in. Indoor White Ceiling Fan

MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH

Page 1

READ AND SAVE THESE INSTRUCTIONS

HUGGER SERIES

CEILING FANS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY

TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If

you have questions, contact the manufacturer at the address or

telephone number listed in the warranty.

2. Before servicing or cleaning unit, or installing a light kit, switch power

off at service panel and lock service panel to prevent power from

being switched on accidentally. When the service disconnecting

means cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

4. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

5. This unit must be grounded.

6. Do not use this fan with any solid-state fan speed control device.

7. Most outlet boxes commonly used for the support of lighting fixtures

are not acceptable for fan support and may need to be replaced,

consult a qualified electrician if in doubt.

Use only UL Listed outlet boxes marked “FOR FAN SUPPORT”.

The outlet box and support structure must be securely mounted and

capable of reliably supporting a minimum of 50 pounds. Use only

the two steel

screws (and lock washers) provided with the outlet box

for

mounting the ceiling fan to the outlet box The outlet box must

not twist or work loose. DO NOT USE PLASTIC OUTLET BOXES.

8. After marking electrical connections, spliced conductors should

be turned upward and pushed carefully up into outlet box. The

wires should be spread apart with the grounded conductor and the

equipment-grounding conductor on one side of the outlet box.

9. Electrical diagrams are for reference only. Light kits that are not

packed with the fan must be UL Listed and marked suitable for use

with the model fan you are installing. Switches must be UL General

Use Switches. Refer to the instructions packaged with the light kits

and switches for proper assembly.

10. After installation is complete, make sure that all connections are

secure to prevent the fan from falling. Make sure all wire connections

are secure, and that there are no exposed conductor strands.

11. Do not use water or detergents when cleaning the fan or fan blades.

A dry dust cloth or lightly dampened cloth will be suitable for most

cleaning.

CAUTION

TO REDUCE THE RISK OF PERSONAL INJURY, OBSERVE THE

FOLLOWING:

1. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power unit.

2. The fan must be mounted with at least 7 feet of clearance between

fan blades and floor.

3. Make sure that your installation will not allow the fan to come into

contact with any adjacent obstacles such as doors, hanging lamps,

etc.

4. If you are installing more than one ceiling fan, do not mix the blade

sets.

5. Do not bend the blade brackets.

6. Do not operate reversing switch while fan blades are in motion.

Fan must be turned off and blades stopped before reversing blade

direction.

7. Do not insert objects in between rotating fan blades.

8. Be careful when working around or cleaning the fan.

9. Please read specification label on product for further information

and requirements.

WEIGHT OF FAN

The weight of your fan is 15.2 lbs.. The weights of light kits, down rods,

and ceiling adapters are listed in the instructions packed with those

accessories.

INSTALLER:

Leave this manual with the

homeowner.

HOMEOWNER:

Use and care instructions on

pages 6 & 7.

Summary of content (16 pages)

PAGE 1
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 1 HUGGER SERIES CEILING FANS READ AND SAVE THESE INSTRUCTIONS WARNING CAUTION TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2.
PAGE 2
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 2 CONTENTS Unpack your fan and check the contents.
PAGE 3
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 3 INSTALL THE FAN 1. Attach the mounting bracket to the outlet box using the two screws and washers provided with the outlet box. (Fig. 4). For best performance be sure the mounting bracket is level and secured firmly against the ceiling. You may need to insert additional washers (not provided) between the outlet box and mounting bracket to make it level. 2.
PAGE 4
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 4 CONNECT WIRING 120 VAC LINE IN FIGURE 6 OPTIONAL WALL CONTROL WH 120 VAC LINE IN GREEN GROUND WIRING BOX LIGHT SWITCH WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR OTHER PERSONAL INJURY, MOUNT FAN ONLY ON AN OUTLET BOX OR SUPPORTING SYSTEM MARKED ACCEPTABLE FOR FAN SUPPORT.
PAGE 5
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 5 FINISH INSTALLATION 1. 2. Swing the motor assembly up into position under the mounting bracket. Secure the bracket to the plate with the screws provided. (Fig. 9) Carefully lift the motor housing onto the mounting bracket, properly align the holes and tighten the motor housing with the 4 screws supplied. (Fig. 10) MOUNTING BRACKET MOTOR ATTACH FAN BLADES SCREWS Your fan is equipped with 2-sided reversible blades.
PAGE 6
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 6 OPERATION Turn on the power and check the operation of your fan. 3-SPEED PULL CHAIN Controls the fan speed as follows: 1 pull - High, 2 pulls - Medium, 3 pulls - Low, and 4 pulls - Off. Speed settings for warm or cool weather depend on factors such as the room size, ceiling height, and number of fans. SLIDE SWITCH Controls directions: forward (switch down) or reverse (switch up).
PAGE 7
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 7 MAINTENANCE SERVICE PARTS IMPORTANT: MAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPT ANY REPAIRS. REFER TO THE SECTION “CONNECT WIRING”. Because of the fan’s natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. (It is not necessary to remove fan from ceiling.
PAGE 8
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH Page 8 WARRANTY NuTone Ceiling Fans and Accessories Limited Warranty WARRANTY PERIOD: NuTone warrants to the original consumer purchaser of its NuTone Ceiling Fans and Accessories will be materially free from defects in materials or workmanship for a period of one (1) year from the date of original purchase. This warranty does not cover glass globes or light bulbs provided with the light kits.
PAGE 9
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH VENTILADORES DE TECHO DE LA SERIE HUGGER Página 9 LEA Y GUARDE ESTAS INSTRUCCIONES ADVERTENCIA PRECAUCIÓN PARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA ELÉCTRICA O LESIONES, SIGA LAS INDICACIONES QUE SE ENUMERAN A CONTINUACIÓN: 1. Utilice esta unidad sólo de la forma indicada por el fabricante. Si desea realizar consultas, comuníquese con el fabricante a la dirección o al número de teléfono que aparece en la garantía. 2.
PAGE 10
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 10 CONTENIDO Desempaque su ventilador y verifique que el contenido esté completo.
PAGE 11
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 11 INSTALACIÓN DEL VENTILADOR 1. 2. Sujete el soporte de montaje a la caja de distribución con los dos tornillos y las arandelas suministrados con la caja de distribución. (Fig. 4). Para un mejor rendimiento, asegúrese de que el soporte de montaje esté nivelado y firmemente sujeto al techo. Probablemente deba agregar más arandelas (no incluidas) entre la caja de distribución y el soporte de montaje para nivelarlo.
PAGE 12
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 12 CABLEADO DE CONEXIÓN ENTRADA DE LÍNEA 120 VCA Conecte el cable de alimentación del ventilador (negro) y el cable de alimentación de luz (azul) al cable de alimentación de color negro de su instalación eléctrica, como se muestra en la figura 6.
PAGE 13
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 13 TERMINACIÓN DE LA INSTALACIÓN 1. 2. Lleve hacia arriba el conjunto del motor hasta su posición debajo del soporte de montaje. Asegure el soporte a la placa con los tornillos suministrados. (Fig. 9) Con cuidado levante la carcasa del motor sobre el soporte de montaje, alinee los orificios correctamente y ajuste la carcasa con los 4 tornillos suministrados. (Fig.
PAGE 14
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 14 FUNCIONAMIENTO Encienda la alimentación y verifique el funcionamiento de su ventilador. CADENILLA DE TIRO DE 3 VELOCIDADES Controla la velocidad del ventilador de la siguiente manera: 1 tirón: alta, 2 tirones: intermedia, 3 tirones: baja, y 4 tirones: apagado. La configuración de las velocidades para temperaturas cálidas o frías depende de diversos factores, como el tamaño de la habitación, la altura del techo y la cantidad de ventiladores.
PAGE 15
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 15 SOLUCIÓN DE PROBLEMAS El ventilador no se enciende. 1. Verifique los fusibles o los disyuntores. 2. Verifique las conexiones de los cables al ventilador y las conexiones del cable del interruptor en la carcasa de interruptores. PRECAUCIÓN: Asegúrese de que el interruptor principal de alimentación esté apagado. El ventilador hace mucho ruido. 1. Asegúrese de que todos los tornillos de la carcasa del motor estén bien ajustados. 2.
PAGE 16
MODELOS CFH52BS • CFH52PB • CFH52RB • CFH52WH Página 16 GARANTÍA Ventiladores de techo y accesorios NuTone Garantía limitada PERIODO DE GARANTÍA: NuTone garantiza al consumidor comprador original de sus ventiladores de techo y accesorios NuTone que estarán libres de defectos en materiales o mano de obra durante un período de un (1) año a partir de la fecha de la compra original. Esta garantía no cubre los globos de vidrio ni las bombillas incluidos con los juegos de luces.