Instructions / Assembly

3
WIRELESS CHIME INSTALLATION
Unobstructed wireless operating range: Up to 100 feet.
NOTE: Wireless pushbutton sold separately. Refer to installation
instructions included with wireless pushbutton.
Keep batteries out of the reach of children.
1. Insertthreealkaline“D”batteries(notincluded)(E)inbatterycom-
partment. Make sure batteries are oriented properly. (Figure 7)
2. Obtain wireless pushbutton(s) (sold separately) and install battery
per wireless pushbutton(s) instructions.
3. Press pushbutton(s) to confirm the chime mechanism and
pushbutton(s)workproperly.Ifthechimedoesnotsound:
a. Confirm the code settings in the chime mechanism and wireless
pushbutton(s) are the same. Jumpers (F) installed on the num-
bered contacts on the chime mechanism must match the switches
or jumpers in the wireless pushbutton(s). (Figures 7 & 8)
E
F
FIGURE7
1 2 3 4 5 6
ON
7 8
SWITCHES2,4,6
INOFFPOSITION
JUMPERSREMOVED(OFF)
FROM 2, 4, 6
b. Verify proper installation of batteries in chime mechanism and
pushbutton(s).
c. Check condition of batteries in chime mechanism and
pushbutton(s). Replace if required.
4. After confirming chime operates, follow steps under section titled
“ManageChimeNotification”beforeproceedingtoStep5.
5. If more than one pushbutton is being installed, refer to Figure 9 to
assign doors.
6. Install the wireless pushbutton(s) at the desired door(s). Refer to
installation instructions provided with wireless pushbutton(s).
7. Place chime mechanism in desired location. Confirm operation by
pressingpushbutton(s).Ifthechimedoesnotsound:
a. Thechimeorpushbutton(s)aremountedonornearstuccoor
metal studs, the transmitter range may be reduced. Use wood
shimstoraisechimeorpushbutton(s)1/4”to1/2”fromsurface.
b. Concrete floors and walls may also reduce transmitter range.
Move chime away from concrete floor or wall.
c. Install chime mechanism closer to wireless pushbutton(s).
8. Remove batteries from mechanism.
9. Mountchimebasetowallusingscrewsprovided(seeStep8in“New
WiredChimeInstallation”section).
10. After mounting chime base to wall, install batteries.
11. Place cover (B) over chime base (A) and press down to install.
A“click”willconfirmthatitissecurelyattached.(Figure1).
12. Proceedtosectiontitled:“ManageChimeNotification”.
PUSH
BUTTON
BATTERY
{
CODESET
JUMPERS1-6
CODESET
SWITCHES1-6
{
WIRELESS PUSHBUTTON - EXAMPLE CODE SETTING
(Pushbutton will have jumpers or switches)
WIRELESS CHIME - EXAMPLE CODE SETTING
JUMPERSREMOVED(OFF)
FROM 2, 4, 6
WIRELESS
CHIME
JUMPERS
{
FIGURE8
1 8
JUMPERS
{
WIRELESS PUSHBUTTON - ASSIGN DOORS
(Wireless pushbutton will have jumpers or switches)
PUSH
BUTTON
BATTERY
{
DOORSET
JUMPERS
*,X,Y
DOORSET
SWITCH8
1 2 3 4 5 6
ON
7 8
1 2 3 4 5 6
ON
7 8
SWITCH8ON
SWITCH8OFF
FIGURE9
OR
FRONT
DOOR
REAR
DOOR
FRONT
DOOR
REAR
DOOR
1 8