Installation Guide

5
Locate the Fixtures
1. Route the 65 feet of low
voltage wire (connected to
controller) around perimeter
of desired protection area.
(Fig. 4)
2. Fixtures should be placed
12 feet or less apart
surrounding perimeter of
protection area. (Fig. 5)
3. Mark location for each
fixture.
NOTE: Do not connect additional wire as this
may cause system to not function properly.
NOTE: Controller can only power up to five
fixtures.
Fixture Installation
1. Install ground stakes. Loosen hard soil and
remove stones and rocks before attempting
to install ground stakes. Use provided striker
cap to protect stakes when hammering. After
installation, stake flange should be flush with
grade level. (Fig. 6)
2. Remove top of fixture by squeezing two
buttons and set aside for use later. (Fig. 7)
STRIKER
CAP
Fig. 4
Fig. 5
Fig. 6
Fig. 7