Installation Guide

10
7. CLEANING AND MAINTENANCE (CONT'D)
STAINLESS STEEL CLEANING:
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Don’t:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction or renovation, cover the hood to
make sure no dust adheres to stainless steel surface.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be
used close to a range.
ENAMEL FINISH:
Clean with warm water and mild detergent only. If discoloration occurs, use a good enamel polish such as automotive polish. DO NOT use
rough abrasive cleaner or porcelain cleaner.
8. OPERATION
Always turn on the hood before beginning cooking in order to establish an air flow in the kitchen. Let the blower run for a few minutes to
clear the air after turning off the range.
The hood is operated using the push buttons located on its front panel.
HC0051
W
1) Lighting push button
2) Less push button
3) More push button
4) ON/OFF push button
1. LIGHTING: Press the lighting push button (1) once to turn the lights on, press once more to turn them off.
NOTE: When lights are on, press the ON/OFF push button (4) twice to turn them off (the blower will start after the first push, but will stop
after the second. If blower and lights are on, press the ON/OFF push button (4) only once to turn lights and blower off.
2. BLOWER: The ON/OFF push button (4) turns the blower on to three speed settings: LOW, MEDIUM or HIGH. Press the ON/OFF (4)
push button once to turn the blower on at the last selected speed (blower symbol will be activated). To increase the blower speed, press
the more push button (3) until the desired speed is obtained. To decrease the blower speed, press the less push button (2) until the
desired speed is obtained. Press the ON/OFF push button (4) to turn the blower off. The last speed used will be memorized.
12 3 4