Installation Guide

5
3. PREPARE THE HOOD
3.2 VERTICAL DISCHARGE ONLY
6” ROUND DUCT INSTALLATION
2. Mount the 6" round adapter/damper on top of the hood, using the 10 screws previoulsy
removed.
3¼” X 10” DUCT INSTALLATION
2. Mount the 3¼" x 10" adapter/damper on top of the hood, using the 10 screws previously
removed.
SCREW LOCATIONS
HO0046
3.1 ALL INSTALLATIONS
1. Lay the hood on its top on a table. Use a piece
of cardboard to avoid damaging the table or
the hood. Slide the main grease cup out and
set aside. Remove the bottom panel 7 retaining
screws. Set bottom panel and screws aside.
GREASE CUP
HO0173
HJ0001
2. Remove both electrical box cover retaining screws. Remove cover and set aside with screws.
Turn the hood over and punch out the wiring knock-out located on TOP of the unit and install
the wire clamp (included).
HO0047
SCREW LOCATIONS
1. Remove the shutoff plate 10 retaining screws. Set the screws aside and discard the
shutoff plate.
HO0051
HJ0003