Installation Guide

8
6. LIGHT BULBS
!
WARNING
Make sure power is switched off at service panel before carrying out any operation on the hood.
This range hood requires two UL approved halogen bulbs (JC type, 12 V, 20 W, G4-base), included.
To replace bulbs:
CAUTION
Take care not to damage the hood finish while using the screwdriver.
1. Carefully insert the blade of a small flat blade screwdriver between light cover and rim and
gently pry out light assembly.
!
WARNING
In order to prevent the risk of personal injury, the halogen lamps must cool down
before removing them.
2. Remove light cover from light assembly and set aside.
CAUTION
Do not touch replacement bulb with bare hands!
4. To reinstall the light cover, insert the 3 light cover tabs in the light assembly slots and gently push
until secured.
HD0399
HD0400
3. Replace bulb with a new JC type, 12 V, 20 W Max, G4 base halogen bulb.
HD0401
LIGHT ASSEMBLY SLOTS