Installation Guide

9
INSTALLATION IN NEW CONSTRUCTION (CONT'D)
WALL INLET INSTALLATION
MODEL 360 WALL INLET
(CF361 AND CF361F ROUGH-INS)
B Remove the cardboard plaster guard.
C Refer to figure at right.
For some drywall or panel
construction, the plaster frame
will extend beyond the finished
wall. In this case, remove
plaster frame from mounting
bracket by removing mounting
screws.
NOTE: When using the model CF361 and CF361F inlet
bracket on walls thinner than 1⁄2", use a 1⁄4" spacer
(not furnished) between the wall and the inlet bracket.
See figure below. Spacer may be made from plywood,
Masonite™, etc. Contact cement may be used to hold
spacer in place during assembly. Configuration of
spacer may vary depending upon installation.
D Refer to figure at right.
Connect 2-conductor low-
voltage wire to terminal
screws on back of wall inlet.
E Guide excess wire back through the hole in inlet bracket and
flanged fitting.
F Refer to figure at right. Place
inlet into mounting bracket and
secure.
NOTE: When wall inlets are installed in walls that are less than
1⁄2" thick or when inlets are installed back-to-back in
a wall, the tube of the wall inlet may extend into elbow
area of the flanged fitting and cause blockage. Shorten
the wall inlet tube to prevent this condition. Refer to
figure below.
For extra thick walls, use Model 399 Extension Sleeve
to connect inlet to the flanged fitting.
MODEL 330 WALL INLET (CF329 ROUGH-IN)
B Refer to figure at right. Connect
2-conductor low-voltage wire
to terminal screws on back of
wall inlet.
C Align inlet mounting holes with
holes in mounting plate.
D Refer to figure at right. Place
inlet into mounting plate and
secure with two provided
screws.
AR0045
2
1
/4"
3
1
/4"
1/4"
INLET MOUNTING
BRACKET
SPACER
WALL LESS THAN
1
/2" THICK.
PLASTER
GUARD
HOLE
AD0057
AE0040
INLET
MOUNTING
PLATE
AE0024A
MODEL CF365
DOUBLE FLANGED
TEE
WALL
INLET
MOUNTING
BRACKET
SHORTEN
WALL
AD0058
INLET
MOUNTING
PLATE
AE0024A