Installation Guide

18
INSTALLATION IN EXISTING CONSTRUCTION (CONT'D)
MODEL 330 SERIES
WALL INLET INSTALLATION
(CF329 ROUGH-IN) (
CONT'D)
E Make sure mounting holes are exactly at top and bottom.
F Connect 2-conductor low voltage wire to terminal screws on
back of wall inlet.
G Refer to figure at right.
Align inlet mounting holes with
mounting plate holes, place
inlet into mounting plate, and
secure with provided screws.
NOTE: If CF382S shorter radius elbow is used, it may be
necessary to use the short mounting screw to avoid
interference with elbow.
FLOOR INLET INSTALLATION IN
NEW & EXISTING CONSTRUCTION
MODEL 360 SERIES INLETS (361 ROUGH-IN)
B Refer to both figures below. After floor inlet location has been
selected, cut a 3 ¹⁄16" x 2
9
⁄16" square hole in floor. Center line
of inlet must be located at least 2½" from wall to allow cover
to be opened when hose is inserted.
C Determine direction of tubing and attach appropriate flanged
fitting to mounting bracket with four (4) screws supplied. Be
sure mounting bracket flange does not interfere with tubing
and seal is securely in place.
D Refer to figure
at right. Position
bracket with
frame and flanged
fitting assembly
into cutout from
below and secure
to sub-floor.
E Refer to figure at
right. Large end of
Model 399
extension sleeve
should be cut
to length to allow
proper seating of
inlet against floor
or carpet.
F Refer to figure at
right. Pull
low-voltage
2-conductor wire
through mounting
bracket and attach
to terminal screws
on back of floor
inlet. Cement
extension sleeve
to Model 360 inlet.
Insert extension
sleeve through
vinyl gasket in
mounting bracket
and firmly seat into flanged fitting.
G For convenience of operation, floor inlet should be installed
to open back toward wall.
H Refer to figure of step D. Secure floor inlet in place with two
screws.
INLET
MOUNTING
PLATE
AE0024A
MOLDING
WALL
TOP VIEW
2
9
/
16
"
3
1
/16"
AD0067A
2
1
/2" MIN.
APPROX.
SIDE VIEW
MOUNTING BRACKET
FLANGE
AD0068A
FLOOR
SUB-FLOOR
2
9
/16"
3
1
/16"
INLET
EXTENSION
FLOOR
INLET
FRAME
MOUNTING
BRACKET
SEAL
FLANGED
FITTING
AD0069A
CUT TO
LENGTH
EXTENSION
SLEEVE
FLANGED
FITTING
MOUNTING
BRACKET
FLANGE
AD0070A
WALL
INLET
EXTENSION SLEEVE
BRACKETFLANGED FITTING
TUBING
AD0071A