Manualshelf

User manual

ManualsBrandsNuTone Manualscomputers & electronicsSwitch VS-89
12
READ AND SAVE THESE
INSTALLATION INSTRUCTIONS!
Accessory
Switch
MODEL:VS-89
INSTALLATION
Used with Vent–Light–Night Light
Combination.
1. Install a double–gang box.
2. Refer to Figure 1. Run power wiring
from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.
3. Secure all wires to outlet box with an
approved box connector.
4. Dress all leads, leaving
approximately 1/2" of bare wire for
making connections.
5. Refer to Figure 1. Make wire
connections. Observe cover plate
markings (Vent–Light–Night Light) when making connections. Make sure
that the switch and the unit it controls are properly grounded.
6. Refer to Figure 2. Using two supplied screws, secure switch bracket
assembly to outlet box adapter plate.
7. Position wall plate over switch assembly and secure with supplied screws.
FIGURE 1
FIGURE 2
HOT (Light)
HOT (Vent)
HOT (Night Light)
COMMON
TO UNIT
VENT
NIGHT
LIGHT
LIGHT
WHITE
BLACK
TO 120vAC, 60Hz
HOUSE POWER
TO UNIT
ADAPTER
PLATE
2 GANG
BOX
TO 120vAC,
60Hz HOUSE POWER
USE A SINGLE-GANG BOX
ADAPTER PLATE TO COVER
DOUBLE GANG BOX.
ADAPTER
PLATE NOT
SUPPLIED
WITH SWITCH.
READ AND SAVE THESE
INSTALLATION INSTRUCTIONS!
Accessory
Switch
MODEL:VS-89
INSTALLATION
Used with Vent–Light–Night Light
Combination.
1. Install a double–gang box.
2. Refer to Figure 1. Run power wiring
from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.
3. Secure all wires to outlet box with an
approved box connector.
4. Dress all leads, leaving
approximately 1/2" of bare wire for
making connections.
5. Refer to Figure 1. Make wire
connections. Observe cover plate
markings (Vent–Light–Night Light) when making connections. Make sure
that the switch and the unit it controls are properly grounded.
6. Refer to Figure 2. Using two supplied screws, secure switch bracket
assembly to outlet box adapter plate.
7. Position wall plate over switch assembly and secure with supplied screws.
FIGURE 1
FIGURE 2
HOT (LIGHT)
HOT (VENT)
HOT (Night Light)
COMMON
TO UNIT
VENT
NIGHT
LIGHT
LIGHT
WHITE
BLACK
TO 120vAC, 60Hz
HOUSE POWER
TO UNIT
ADAPTER
PLATE
2 GANG
BOX
TO 120vAC,
60Hz HOUSE POWER
USE A SINGLE-GANG BOX
ADAPTER PLATE TO COVER
DOUBLE GANG BOX.
ADAPTER
PLATE NOT
SUPPLIED
WITH SWITCH.

Summary of content (2 pages)