Use and Care Manual

TIPS: Always unplug the Magic Bullet
®
when cleaning or assembling.
STUBBORN CLEANUP: If ingredients dry inside the Magic Bullet
cups, make your cleanup a snap by lling the cup about 2/3 full with room
temperature soapy water (not hot) and screw on the Cross Blade. Place the cup/
blade assembly on the Power Base for about 20-30 seconds. This will loosen the
stuck ingredients, and with a light scrub and rinse, you’ll be all done.
CAUTION: Do not put the Cross Blades in the dishwasher as the heat may
cause the gaskets to deteriorate or come loose.
Never submerge the Power Base in water or place it in dishwasher. Never put
your hands or utensils near the moving Cross Blade and never use your hands or
utensils to press the activator buttons down while the Power Base is plugged in.
EASY
CLEAN-UP
CLEANING THE MAGIC BULLET
®
The Magic Bullet
®
doesn’t only quickly prepare food, it also saves
a huge amount of cleanup time! This little machine lets you make
delicious pasta sauces, salsa, sandwich llings, fresh soups, and
more without dirtying a single cutting board, pot, or pan.
Cleaning all your Magic Bullet
®
pieces is also a snap. All cups and
Stay-Fresh lids can be washed in the top shelf of the dishwasher,
and the blades can be quickly hand washed with soap and water.
CLEANING THE MAGIC BULLET
®
POWER BASE
The Power Base doesn’t generally get dirty, but liquids can leak
out of cups and into the base and activator tabs if the cross blade
isn’t twisted on tightly enough during blending. If this happens,
UNPLUG THE POWER BASE (this is very important), then wipe
the inside and outside of the base with a damp cloth. Let the
machine dry for a few minutes before using again.
If leakage isn’t immediately or thoroughly cleaned, it can dry in
the Power Base, leaving sticky residue on the activator tabs.
Sticky tabs can get jammed in lock-on mode during blending,
causing the motor to continue spinning even after the cup/
cross blade assembly is removed from the base. If this happens,
immediately unplug the Power Base. Using a damp cloth, work
the activator buttons up and down to soften and remove any
stuck-on substances. Let the Power Base dry for a few minutes
before blending again.
1918