Use and Care Manual

• If the motor stops working, unplug the Power Base and let it cool for a few hours
before attempting to use it again. Your Magic Bullet
®
has an internal thermal
breaker that shuts off the unit when it overheats. Letting the thermal breaker cool
down should allow the Power Base to reset.
• DO NOT ALLOW BLENDED MIXTURES TO SIT IN A SEALED CUP FOR
LONG PERIODS OF TIME! Sugar in fruits and vegetables can ferment, causing
pressure to build up and expand in the cup that can cause ingredients to burst
and spray out when moved or opened. Unscrew the lid and open the cup for a few
moments to release any pressure that has built up. If you do not plan to consume
the contents immediately, use the stay fresh lid to close the cup. Periodically
unscrew the lid to release internal pressure if storing longer than a few hours.
CROSS BLADE SAFETY
• CROSS BLADES ARE SHARP! HANDLE CAREFULLY. Use care while handling
the Cross Blades, do not touch the Cross Blade edges to avoid injury.
• AVOID CONTACT WITH MOVING PARTS! Keep hands and utensils out of
and away from the Cross Blade while blending food to reduce the risk of severe
personal injury.
• TO REDUCE RISK OF PERSONAL INJURY OR PROPERTY DAMAGE, MAKE SURE
THE Cross Blade is securely screwed (hand tightened) onto the cup before
placing it on the Power Base and operating the Magic Bullet
®
.
• NEVER STORE THE CROSS BLADE IN THE POWER BASE WITHOUT
A CUP ATTACHED. THE EXPOSED BLADES CAN PRESENT A VERY
DANGEROUS HAZARD.
• To prevent leakage and/or property damage, always make sure your Cross
Blade is undamaged and the Gasket is completely seated in the cross blade
before each use. Leakage may cause residue buildup and damage the Power
Base. Contact Customer Service for assistance if any component is damaged or
loose, or if you have any questions.
• We recommend replacing your Cross Blade every 6 months or as needed for
optimal performance.
• Once you have nished blending with your Magic Bullet
®
, wait to remove the cup/
Cross Blade assembly from the Power Base until the motor comes to a complete
stop and the unit powers down completely. Taking the cup off the unit prior to
complete power down can cause damage to the Cross Blade coupling and or
motor gear.
• Never run the Magic Bullet
®
without food or liquid contents in any of the cups.
•
Your Magic Bullet
®
is not intended to be an ice crusher and attempting to crush ice may
result in permanent damage to the Cross Blades and may cause the unit to malfunction
and cause personal injury or property damage.
IMPORTANT SAFEGUARDS
When Using Electrical Appliances Like Your Magic Bullet
®
,
Basic Safety Precautions Should Always Be Followed:
WARNING! TO AVOID THE RISK OF SERIOUS INJURY, CAREFULLY READ
ALL INSTRUCTIONS BEFORE OPERATING YOUR MAGIC BULLET
®
.
SAVE THESE INSTRUCTIONS!
HOUSEHOLD USE ONLY
GENERAL SAFETY INFORMATION
• Close supervision is necessary when an appliance is used by or near children.
Keep cord out of reach of children.
• NEVER LEAVE THE MAGIC BULLET
®
UNATTENDED WHILE IT IS IN USE.
• Do not use your Magic Bullet
®
for anything other than its intended use.
HEAT AND PRESSURE SAFETY
• DO NOT BLEND HOT INGREDIENTS OR LIQUIDS! Never put hot
ingredients in any of the cups before or while blending. Heated ingredients can
cause pressure to build up in the sealed cup causing possible expulsion of hot
ingredients which may cause personal injury or property damage. Start with
room temperature or cooler ingredients (21°C/70°F or cooler).
• To prevent overheating and pressure build up, NEVER ALLOW THE MAGIC
BULLET
®
TO RUN MORE THAN ONE MINUTE at a time as it may result in
the ingredients overheating which can increase the pressure and may cause the
cup to burst, resulting in possible personal injury or property damage.
• Never blend carbonated liquids or effervescing ingredients (e.g., baking soda,
baking powder, yeast, cake batter, etc.). Built-up pressure from released gases
can cause the cup to burst resulting in possible personal injury or property damage.
• FRICTION FROM THE ROTATING EXTRACTOR BLADES WHILE
BLENDING CAN CAUSE INGREDIENTS TO HEAT AND GENERATE
INTERNAL PRESSURE IN THE SEALED CUP, IF LEFT TO RUN FOR
LONGER THAN A MINUTE. IF THE CUP IS WARM TO TOUCH, ALLOW
IT TO COOL BEFORE CAREFULLY OPENING POINTED AWAY FROM
YOUR BODY TO AVOID INJURY.
• After blending ingredients allow the contents to settle and release any pressure
that may have built up during the extraction process by slowly unscrewing the cup
from the blade assembly. Have the cup pointed away from you in case there is any
built-up pressure.