Use and Care Manual

1
Load the ingredients into
the Tall Cup, Short Cup or
Party Mug (do not exceed
the MAX line).
2
Twist on the Cross Blade
until the blade and cup have
a tight seal.
3
Line up the tabs on the cup
and with the tabs on the
Power Base. Press the cup
down onto the base to turn
on the machine.
Using the Magic Bullet
®
is as
easy as 1, 2, 3:
USING THE
MAGIC BULLET
®
“LOCK ON” MODE:
For hands-free operation,
press down and gently turn
the cup clockwise until the
tabs lock under the lip of the
Power Base. Once you are
in Lock On Mode, the motor
will run continually (do not run
for longer than a minute!). To
turn it off, simply twist the cup
back counter-clockwise and
release the cup.
CAUTION: Before using the
cross blade, check the gasket to
make sure it is not damaged and it is
completely seated in the Cross Blade
unit before each use.
Never put your hands or utensils
near the moving Cross Blades and
never use your hands or utensils to
press the activator buttons down
while the Power Base is plugged in.
IF THE CROSS BLADE STOPS
SPINNING WHILE IN LOCK ON
MODE, IMMEDIATELY UNPLUG
THE MAGIC BULLET
®
. Hard
ingredients like carrots or celery can
get stuck in the Cross Blade and
stop it from turning. If this happens,
UNPLUG THE MAGIC BULLET
®
RIGHT AWAY. Remove the blade/
cup assembly from the Power Base,
and give ingredients a good shake
to unblock the Cross Blade. If the
Cross Blade still remains obstructed,
twist the Cross Blade attachment
off of the cup and carefully spin the
metal blades using a utensil (not
your ngers) to release the blockage.
Reattach the Cross Blade to the cup,
plug in the Magic Bullet
®
and try
again. It should spin normally.
NEVER RUN THE MAGIC BULLET
FOR MORE THAN ONE MINUTE
AT A TIME, AS IT CAN CAUSE
PERMANENT DAMAGE TO THE
MOTOR. If the motor stops working,
unplug the Power Base and let it cool
for a few hours before attempting
to use it again. Your Magic Bullet
®
has an internal thermal breaker that
shuts the unit off when it overheats.
Letting the thermal breaker cool
down should allow it to reset.
HERE’S HOW IT WORKS:
The Magic Bullet
®
will blend for as long as
you press the cup down onto the Power
Base. To stop blending, simply release
pressure on the cup.
1312