User guide.
Important safeguards. Warning! To avoid the risk of serious injury, carefully read all instructions before operating your NutriBullet®. When using any electrical appliance, basic safety precautions should always be observed, including the following important information.
When using the sealed cup, only blend for one minute or less. Friction from prolonged operation can heat ingredients and generate internal pressure in the sealed container. This pressure can cause the cup and blade to separate or blended contents to erupt from the container, resulting in possible personal injury and/or property damage. If the sealed NutriBullet® cups are warm to the touch, power off your machine leaving the cup attached to the base and allow the vessel to cool for fifteen minutes or more.
WARNING! blending container to burst, resulting in possible injury and/or property damage. BLENDING WITH THE PITCHER: Use extra caution when blending hot liquids or ingredients in the pitcher. Steam and splattering ingredients can escape through the pitcher lid, potentially scalding and/or burning the user. NEVER blend hot liquids or ingredients in your pitcher without the pitcher lid and vented lid cap locked and attached.
• TO REDUCE THE RISK OF PERSONAL INJURY OR PROPERTY DAMAGE, never place the easy-twist extractor blade on the motor base without the cup properly attached. Make sure the easy-twist extractor blade is securely twisted (hand-tightened) onto the NutriBullet® cup before placing it on the motor base and operating the NutriBullet® Smart Touch Blender™ Combo.
• Keep hands and utensils, other than the tamper provided, out of container while blending to reduce the risk of severe injury to persons or damage to the blender. The cover must remain in place when using the tamper through the cover opening. A scraper may be used but must be used only when the blender is not running. • If you need to push ingredients closer to the blade, ONLY USE THE TAMPER PROVIDED with the NutriBullet® Smart Touch Blender™ Combo.
WARNING! • The Smart Touch Blender™ Combo is ready to operate when unit is plugged in and power icon is illuminated. Avoid inadvertent contact with the touch screen display. The NutriBullet® Smart Touch Blender™ Combo is not intended for use on the stove top. Do not place the motor base or any NutriBullet® accessory on the stove or microwave or immerse in boiling water. This may result in damage to the accessory. • Do not allow the cord to hang over the edge of the table or counter.
space beneath and around the motor base to permit proper air circulation. Vents on the bottom of the product are provided for ventilation to ensure reliable motor operation and to prevent overheating. MEDICAL SAFET Y • The information contained in this User Guide or Recipe Guide is not meant to replace the advice of your physician. Always consult your physician regarding health and nutrition concerns.
• Always use genuine NutriBullet® replacement parts. After market parts are not made to NutriBullet’s specifications and may damage your unit or cause serious injury. • Periodically inspect all NutriBullet® Smart Touch Blender™ Combo components for damage or wear that may impair proper function or present an electrical hazard. Make sure that the power cord and plug are undamaged. Discontinue use and replace blending vessels if you detect cracking, cloudiness, or damage to the plastic.
Contents. 12 What’s included 13 Assembly guide 14 Getting started 14 14 18 20 Blending control panel 20 22 24 Safety guide Pitcher assembly & use NutriBullet® cup assembly & use Manual speeds Intelligent programs Care & maintenance 24 26 How to clean the NutriBullet® How to store 26 Replacement parts 27 NutriBullet® Smart Touch Blender™ Combo one-year limited warranty 30 Warranty registration Thank you for purchasing the NutriBullet® Smart Touch Blender™ Combo.
What’s included.
Assembly guide.
PLEASE KEEP THESE IMPORTANT SAFEGUARDS IN MIND WHEN USING THE APPLIANCE: Use extra caution when blending hot liquids or ingredients in the pitcher. WARNING! Getting started. • Make sure the base is plugged in for use. • Never run the appliance while empty. • Appliance accessories are not intended to be used in the microwave as it may damage the accessories. When blending hot liquids in the vented pitcher, add liquid and solid ingredients to your pitcher below their respective MAX lines.
3 2 Place the lid on top of the pitcher and press down firmly until locked in place. Place the lid cap over the lid opening, then press down and twist until locked in place. Place the pitcher on a clean, dry, level surface. Add the ingredients to the pitcher, making sure they do not exceed the MAX line. NOTE: The blending pitcher is marked with two MAX lines: one for solid ingredients (higher line) and one for liquids (lower line).
NOTE: If you need to add additional ingredients while blending, switch the setting to LOW and remove the lid cap from the pitcher lid, leaving the lid attached. Add ingredients through the hole in the top of the lid, followed by the tamper if necessary. Replace the lid cap, then increase to your desired speed. DO NOT attempt to add items through the vent hole when blending HOT ingredients. 6 To begin blending, select a manual speed or program on the Blending Control Panel.
7 8 When you have reached your desired consistency, stop the appliance by pressing POWER . If you are using a program, you will hear a beep when the program has completed. Wait for the blades to stop turning. The unit will enter idle-mode. The timer will reset and the Blending Control Panel will remain illuminated. Press POWER again to turn off the unit completely and the illuminated display will turn off. Twist pitcher counterclockwise and lift off the motor base.
NutriBullet® cup assembly & use. Review all warning and caution statements in the Important Safeguards section (pg 3-9) and on the previous page before proceeding to Step 1. 3 Twist the easy-twist extractor blade onto the cup until tightly sealed. WARNING: Handle the easy-twist extractor blade assembly with care, as the blades are sharp. Never leave the appliance unattended while in use. 1 Place the motor base on a clean, dry, level surface such as a counter or table.
6 7 To begin blending, select a manual speed or program on the Blending Control Panel. To pause blending, press the current speed or program once, the unit will stop running and the timer will pause. To resume blending, press a manual speed or the same program. When you have reached your desired consistency, stop the appliance by pressing POWER . The unit will enter idle-mode. The timer will reset and the Blending Control Panel will remain illuminated. Press POWER again to turn off the unit completely.
Blending control panel: manual speeds. TURNING ON/OFF The power button controls the master power of the appliance. If pitcher with pitcher lid or NutriBullet® cup is locked in place, pressing POWER will indicate the motor is powered on and illuminate the Blending Control Panel. TIMER When using a blending speed: timer starts at zero (00:00) and increases during operation, showing time elapsed since blending began. When using program presets: timer counts down during operation until program is completed.
WARNING! NEVER BLEND HOT LIQUIDS OR OTHER HOT INGREDIENTS IN ANY SEALED NUTRIBULLET® CUP. Doing so may cause excessive pressure buildup, resulting in risk of personal injury or property damage. Hot items should only be blended in the pitcher using proper safeguards. MEDIUM SPEED Use to cream soups, blend sauces and spreads, or mix dips. Also great for grinding nuts, making mixed drinks, powdered drinks or milkshakes.
Blending control panel: intelligent programs. PURÉES Delivers a perfectly smooth texture — ideal for dips, sauces and spreads of all kinds. SOUPS Blends sweet or savory ingredients into the silkiest of ready to heat soups and chilled gazpachos. The Soups program is only available when using the pitcher. NOTE: The Soups program does not heat the ingredients you are blending. Always be careful when opening the pitcher after blending hot or warm ingredients.
TO SELECT A PROGRAM Press the desired program to turn on. The selected program will illuminate and the rest of the blending control panel will disappear. The program will start to run, and timer will countdown until the program is complete. When the program is complete, there will be an audible alert and main blending control panel will be illuminated. To pause a program before completion, press the active program. The motor will stop and the timer will pause counting.
Care & maintenance. Cleaning the NutriBullet® is easy. The pitcher is dishwasher-safe while the cups and to-go lids are TOP RACK dishwasher-safe. The easytwist extractor blade and motor base can be quickly hand-washed with soap and water. Read on for best practices. Here’s how to clean the NutriBullet®: STEP 1: MOTOR BASE: The most important thing — ALWAYS POWER OFF THE UNIT and UNPLUG the motor base from the power outlet when it is not in use.
EASY-TWIST EXTRACTOR BLADE: NUTRIBULLET ® CUPS & TO-GO LIDS: • Blades are sharp! Handle the easy-twist extractor blade with care when cleaning! It is best to clean blades immediately after use to reduce buildup of residue. If food particles get stuck, use a small brush or sponge to target and dislodge them. These items are TOP RACK dishwasher-safe. We recommend rinsing and briefly scrubbing them with a dish brush to remove any remaining debris before placing in the dishwasher.
• Regularly check the structure of the pitcher and twisting threads for cracking, crazing, or breakage. If damaged, replace immediately to prevent possible personal injury. TAMPER • Always hand-wash the tamper with soap and water. Stuck-on ingredients might require extra scrubbing from a dish brush or sponge. How to store: Store the NutriBullet® Smart Touch Blender™ Combo pitcher upright with the pitcher lid secured on top. Do not place anything on top of the pitcher lid.
NutriBullet® Smart Touch Blender™ Combo one-year limited warranty. LIMITED WARRANTY FOR NUTRIBULLET ® NutriBullet's limited warranty obligations are confined to the terms set forth below: NutriBullet, LLC (“NutriBullet”) warrants this NutriBullet® against defects in materials and workmanship for a period of one year from the date of original retail purchase.
customer service department you will be asked for your name, address, telephone number and to provide proof of the original purchase (receipt) containing a description of the product(s), purchase date, and the appropriate NutriBullet® serial number(s). Before you send your product for limited warranty service please make sure to keep a copy of all relevant documents for your files (receipt, etc.).
(c) to a product or a part that has been modified in any way; (d) if any NutriBullet® serial number or trademark has been removed or defaced; and or (e) if the product has been used with an adapter/converter. THIS LIMITED WARRANTY AND THE REMEDIES SET FORTH ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, REMEDIES AND CONDITIONS, WHETHER ORAL OR WRITTEN, EXPRESS OR IMPLIED.
Warranty registration. Please visit nutribullet.com/ warranty-registration or call 1 (800) 523-5993 to register your new NutriBullet® Smart Touch Blender™ Combo. You will be asked to enter the Serial Number* of your product, along with the purchase date and place of purchase. The registration will enable us to contact you in the unlikely event of product safety notification.
1 (800) 523-5993 | nutribullet.com NutriBullet, LLC | www.nutribullet.com | All rights reserved. NutriBullet® and the NutriBullet logo are trademarks of CapBran Holdings, LLC registered in the U.S.A. and worldwide. Illustrations may differ from the actual product. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice.