User Guide

1514
CAUTION:
• Do not run the Power Base in excess of 1 minute per interval. Do not run
the Power Base for more than three 1-minute intervals without allowing
it to cool for 2-3 minutes after the third extraction. Running the motor for
more than 1 minute consecutively in any interval may result in permanent
damage to the Power Base.
• Friction from the rotating blade when extracting can cause ingredients
to heat and generate internal pressure in the sealed vessel. If the vessel
is warm to touch, allow to cool before carefully opening pointed away
from your body.
Fill ingredients into the Cup size of your
choice.
Press the vessel blade side-down onto the
Power Base. Press down and twist to the
left to extract for no longer than 1 minute.
If more extraction is needed, wait 1 minute,
then repeat the extraction process in 1
minute intervals, up to 3 times as needed
to achieve the desired consistency. If more
than three 1-minute extractions are needed,
allow the power base to cool for 2-3 minutes
after the third extraction before beginning
the next round. You can see the extraction
process happening. Keep an eye on the
consistency. Your smoothie is ready when it
looks smooth and creamy!
To turn off the NutriBullet — simply twist
in the opposite direction (to the right) to
release the tabs and stop pressing down
on the Cup. Once the Power Base stops
completely, remove the Cup from the Power
Base.
1
2
3
4
5
Add liquid of your choice up to the MAX
line. (Liquid is required!).
Twist the Extractor Blade onto the Cup and
hand tighten to make sure the vessel has
been sealed securely.
BLENDING
A SMOOTHIE
NUTRIBULLET, LLC