User Manual

www.NutrichefKitchen.com6
2. Plug in the Power Cord to start boiling
1. Connect Power Cord to Hot Water Dispenser.
2. Plug Power Cord to the power outlet.
After connect to the outlet, the“BOILING“ indicator lights up and water starts to
boil automatically till reaching boiling temperature of (212°F).
3. When Water is boiling, the Hot Water Dispenser will switch in to keep warm
mode. The Defaul (or customer select) Temp idicator of 185°F lights up.
• Hot Water Dispenser will re-boil again if the water temperature drops below
the set temperature level.
• If Hot Water Dispenser do not boil automatically, press “RE-BOIL” button to
boil water.
4. Each time the“TEMP SET“ button is pressed, the keep warm temperature
indicator will switch by following sequence; 185°F -> 208°F-> 149°F -> 185°F ->
3. TWO WAYS TO DISPENSE HOT WATER
1. Press "UNLOCK" button, the unlock light is on.
(Hot Water Dispenser will auto lock if idle for 10 seconds.)
www.NutrichefKitchen.com 7
2. Push Button Dispensing: Press "DISPENSE" button to dispense hot water into cup.
Cup Touch Dispensing: Holding cup up to touch the cup switch behind the
spout to dispense hot water into cup.
NOTE:
After water has boiled without dispensing for a period. Some air might become
trapped in the water pump to prevent pumping water. Simply open then close
the lid to solve this issue.
4. STAND-BY FUNCTION
1. During water boiling, press "RE-BOIL" button once, kettle will turn into STANDBY
mode and stop boiling. To resume boiling press "RE-BOIL" again.
Start Boiling Boiling Finished
Boiling indicator is ON Boiling indicator is OFF;
Temp indicator is ON
Idle for
10 seconds
UNLOCK indicator is ON UNLOCK indicator is OFF
PUSH
PUSH