User Manual

www.NutrichefKitchen.com8
2. If Dispenser is in keep warm mode, press "RE-BOIL" button twice to set Hot Water
Dispenser into STANDBY mode. Resume boiling by pressing "RE-BOIL"again.
MAINTENANCE
BODY
Wipe the Hot Water Dispenser body with soft dry cloth.
• Wipe with dump cloth, if the stain is hard to remove. (never use soaked cloth!)
• Don't use thinner to clean, it might crack the plastic casing.
• Any cloth containing chemicals might cause color changing of body.
WARNING: This Hot Water Dispenser is not Dishwasher safe!
REMOVE SCALE DEPOSIT
If using tap water, the minerals in the water will deposit on the surface of stainless
steel lining over time. This deposit scale will shorten the life of this Hot Water
Dispenser. Please clean this Hot Water Dispenser with citric acid at least once a
month. Please follow the instruction on the citric acid's package to clean and
remove mineral deposits.
LINING
Wipe lining with dump sponge. Don't use detergent or any kind of abrasive brush.
REPLACE SILICON SEAL
The silicon seal may become damaged after a long period of use.
It should be replaced. Call our service line or order on our web store for replacement
silicon ring.
www.NutrichefKitchen.com 9
It is easy to replace silicon ring by removing four screws inside bottom of upper lid
and then removing the stainless steel plate. Remove the silicon ring and replace
with new ring. Put back Stainless Steel plate and tighten four stainless steel
screws.
STORAGE
1. Pull the plug out of outlet.
2. Pull the cord out of kettle.
3. Remove upper lid.
4. Pour all water out of kettle.
PUSH PUSH AGAIN
Push down the LID LOCK
then hold and pull the
LID LOCK up
Hold on the Hot Water
Dispenser body then
pull the lid out of the
Hinge.
Put the lid back to the
Hinge.