How to Guide

INSTRUCTIONS
GENERAL INFORMATION
• Never place the appliance next to naked ames or other heat sources.
• Do not open the lid more often than required. Do not leave the lid open more often
than is necessary. This will inuence the duration of the cooling or keeping warm.
• The duration of the cooling or keeping warm is also dependent on the ambient
temperature.
• The appliance is not suitable for permanent operation.
• The appliance can be connected to two dierent energy sources:
- Alternating current 110V~
- Direct current 12V
• The respective indicator lamp will indicate the mode:
- Green for cooling
- Red for keeping warm
• Do not switch directly from one operating mode into the other. If you would like to
change the operating mode, turn the appliance Off. Wait about 30 minutes before you
switch it to the other operating mode.
COOLING
• You may keep cold foods cold for several hours.
• Turn the switch to the “COLD” position
• For best results, only store already cooled food/ beverages in the cooler. Select a place
of use that is protected from direct sunlight.
KEEPING WARM
• You may keep hot food / beverages warm for several hours, maximum 122°F to 140°F
• Set the switch to the “HOT” position.
• The peltier element will switch off and on at intervals to maintain the temperature.
The red control light will be lit up when the peltrier element is in operation and when
the fan is running.
• The appliance is not designed for reheating. Cold food will only warm up slightly after
about 2 hours.
CONNECTION TO THE ALTERNATING CURRENT
1. Remove the power cord for the direct current, if necessary.
2. Check to make sure that the mains voltage that you want to use is110 V~.
3. Plug the power cord for alternating current into the ~AC socket on the appliance.
4. Connect the device to a properly installed earthed socket.
5. Set the switch to COLD for cooling and to HOT for keeping warm.
4
CONNECTION TO THE DIRECT CURRENT
1. Remove the power cord for the alternating current, if necessary.
2. Turn on the engine of the motor vehicle.
3. Plug the power cord for direct current into the DC socket on the appliance.
4. Connect the appliance to the cigarette lighter in the motor vehicle.
5. Set the switch to COLD for cooling or to HOT for keeping warm.
NOTE:
Save the battery of your motor vehicle. Only run the appliance in the motor vehicle while
the engine is running.
TERMINATING OPERATION
There is no automatic shut-off . The appliance runs permanently while it is connected to
a power supply and switched on.
1. Set the switch to the “OFF” position.
2. Unplug the power cord from the socket or the cigarette lighter.
3. Unplug the power cord from the appliance.
CLEANING
WARNING:
• Always unplug the power cord from the appliance and from the socket / the cigarette
lighter!
• Never immerse the appliance in water! Otherwise this might result in an electric shock
or re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Use a moist towel to clean the inside and the outside. You may add a dishwashing liquid
to the towel.
• Dry it with a cloth afterwards.
• Fasten the lid back into the holder.
Storage
• Clean the appliance as described and allow it to dry.
• We recommend that you keep the appliance in the original packaging if it will not be
used for long periods.
• Always store the appliance out of the reach of children in a dry, well ventilated place.
www.NutrichefKitchen.com