NUUGARDEN USA 6366 Corley Road, Norcross GA 30071.
DANGER FIRE OR EXPLOSION HAZARD If you smell gas: Shut off gas to the appliance. Extinguish any open flame. If odor continues, leave the area immediately. After leaving the area, call your gas supplier or fire department. Failure to follow these instructions could result in fire or explosion, which could cause property damage, personal injury, or death. WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
SAFETY INFORMATION SAFETY INFORMATION Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so WARNING The installation of this unit must adhere to local codes or Propane Storage and Handling Code, CSA B149.2. THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a ventilated space and shall not be used in any enclosed area.
HARDWARE SAFETY INFORMATION Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied directly by us . Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. For assistance with repair or replacement of the burner or any other parts, contact to us. NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before assembling.
CONTENTS B J C D E K G H I F A L Item Description Qty A Table Leg 1 B Table Leg 1 C Table Leg 1 D Panel 1 E Panel 1 F G Panel Door 1 1 H Tank Hoider/Base 1 I Contorl Knob Table Lid J K L Fire Table with Burner PVC cover 1 1 1 1 ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 6. Place propane gas tank (not included) into the metal stand ( ). Make sure the gas tank sits on the metal stand ( ) completely. 7.Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the preassembled regulator from the table top ( ) to the cylinder valve by turning the regulator coupling nut clockwise. Make sure it is fastened securely and tighten connections by hand only.
OPERATION Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the gas valve off, disconnect propane gas tank and do not use the appliance until the leak is repaired.
TROUBLESHOOTING Problem Heating unit won’t light Cause Solution Igniter pin and burner are wet Dry off with a soft cloth Igniter battery is incorrectly inserted Check which direction the battery is inserted Contact us.
