Getting Started Guide

FCC Information

FCC Warning:

Any changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause interference

2. This device must accept any interference, including interference that may cause

undesired operation of the device.

2. Changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses

and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet an a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Before a new device is a available for sale to the public, it must be tested and certiﬁed

to the FCC that it does not exceed the exposure limit established by the FCC, tests

for each device are performed in positions and locations as required by the FCC.

For body worn operation, this device has been tested and meets the FCC RF

exposure guidelines when used with an accessory designated for this product or

when used with an accessory that contains no metal and that positions the handset a

minimum of 10mm from the body.

Non-compliance with the above restrictions may result in violation of RF exposure

guidelines.